Maxima Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: LoveSick
Showing results 1 to 25 of 500
Search took 0.24 seconds.
Forum: 5th Generation Classifieds (2000-2003)
04-03-2019, 02:11 AM
Replies: 3
Views: 912
Posted By LoveSick

5th Gen Maxima Front Black Floor Mats, Cupholder inserts, cargo net, and Fan Motor

I have a pair of front floor mats (for black interior), cupholder inserts and cargo nets for sale. They came from my 2000 Maxima SE.

I also have a new OEM radiator fan motor.
Forum: 5th Generation Maxima (2000-2003)
11-05-2010, 03:50 AM
Replies: 27
Views: 16,072
Posted By LoveSick

Sorry for the lack of update! During late summer...

Sorry for the lack of update! During late summer I stopped the insurance on the Maxima and put my G35 and M45 back on the road. I was unable to drive or test the Maxima; it sat in my garage for over...
Forum: 5th Generation Maxima (2000-2003)
09-29-2010, 12:40 PM
Replies: 27
Views: 16,072
Posted By LoveSick

Do you have a 5th gen? I find it very hard...

Do you have a 5th gen?

I find it very hard to replace the KS on the 5th gen. It's virtually impossible to reach it
Forum: 5th Generation Maxima (2000-2003)
09-28-2010, 03:37 AM
Replies: 27
Views: 16,072
Posted By LoveSick

- Drained fluid and filled with Amsoil 2 months...

- Drained fluid and filled with Amsoil 2 months ago.

- Use Redline fuel injector cleaner once a month.

- Used seafoam in engine oil before previous oil change about 1 month ago.

- Used...
Forum: 5th Generation Maxima (2000-2003)
09-26-2010, 05:59 PM
Replies: 27
Views: 16,072
Posted By LoveSick

Thanks for the advice. Based on the feedbacks and...

Thanks for the advice. Based on the feedbacks and further research, I am suspecting knock sensor.

I looked at the FSM regarding the location of the KS. It is on the cylinder block. However I...
Forum: 5th Generation Maxima (2000-2003)
09-26-2010, 01:26 PM
Replies: 27
Views: 16,072
Posted By LoveSick

I did a compression test when I replaced the...

I did a compression test when I replaced the spark plugs. I forgot exactly what the figure was, but all six cylinders had consistent numbers spot on at stock specification. I am sure that quarter...
Forum: 5th Generation Maxima (2000-2003)
09-25-2010, 11:20 PM
Replies: 27
Views: 16,072
Posted By LoveSick

Major Power Loss 3.0L SE

Before anybody decides to tell me to do a search... I have been searching for a solution to my power loss issues for over 6 months. It took serious courage for me to post a thread about this!!! :eek:...
Forum: 5th Generation Maxima (2000-2003)
07-12-2010, 02:04 PM
Replies: 50
Views: 43,281
Posted By LoveSick

Very helpful posts! I have been having headlight...

Very helpful posts! I have been having headlight low beam issues on my car (DTRL Canadian 2000 Maxima SE with 150,000km) for a few months now. My driver's side low beam wouldn't work while everything...
Forum: 5th Generation Maxima (2000-2003)
05-21-2010, 12:23 AM
Replies: 21
Views: 27,967
Posted By LoveSick

Autozone doesn't make its own starters; it...

Autozone doesn't make its own starters; it purchases from manufacturers that produce, rebuild, or repackage parts. It depends on the brand you get. I have a Bosch starter (rebuilt using factory core)...
Forum: 5th Generation Maxima (2000-2003)
11-11-2009, 09:40 PM
Replies: 10
Views: 1,898
Posted By LoveSick

I think MOST of the oil filters for the Maxima...

I think MOST of the oil filters for the Maxima have drain back valves built into them. I can be wrong though, but most quality filters have them.

The clatter is normal. IF it is persistent on...
Forum: 5th Generation Maxima (2000-2003)
11-11-2009, 09:36 PM
Replies: 17
Views: 1,056
Posted By LoveSick

To be honest, from my professional standpoint,...

To be honest, from my professional standpoint, this engine bay doesn't look all that unusual.

I am NOT saying that these rust are normal, but these rusts are very common in cars driven by the...
Forum: 5th Generation Maxima (2000-2003)
11-07-2009, 04:53 PM
Replies: 151
Views: 10,706
Posted By LoveSick

Well said. :thumbsup:

Well said. :thumbsup:
Forum: 5th Generation Maxima (2000-2003)
11-07-2009, 12:48 AM
Replies: 22
Views: 5,582
Posted By LoveSick

Notice the small rubber boot or gromet on one of...

Notice the small rubber boot or gromet on one of the sliding pins? You can safely remove that. That is often the cause of caliper pin seizing. That boot swells up from heat and pressure, and...
Forum: 5th Generation Maxima (2000-2003)
11-07-2009, 12:07 AM
Replies: 2
Views: 604
Posted By LoveSick

Yes they will fit. Although the 5th and 5.5...

Yes they will fit. Although the 5th and 5.5 generation maximas have SLIGHTLY larger brakes, they are not going to hinder fitment of the 4th gen wheels.
Forum: 5th Generation Maxima (2000-2003)
11-06-2009, 10:13 PM
Replies: 42
Views: 2,449
Posted By LoveSick

If you wash the engine often, getting the...

If you wash the engine often, getting the alternator wet with water, dressing, and degreaser, then the alternator would go prematurely. Alternators do not have an expiry date. They wear out due to...
Forum: 5th Generation Maxima (2000-2003)
11-06-2009, 10:05 PM
Replies: 20
Views: 833
Posted By LoveSick

I believe your car should have the wiring harness...

I believe your car should have the wiring harness for the heated seats preinstalled. You simply have to trace it through the panels. If you are getting the heated seats, make sure you grab the...
Forum: 5th Generation Maxima (2000-2003)
11-06-2009, 10:00 PM
Replies: 22
Views: 5,582
Posted By LoveSick

By sliders, you mean the caliper sliding pins? ...

By sliders, you mean the caliper sliding pins?

If so, then do not let the shop charge you so much for the job. The sliders on the maxima are made from a very strong steel. They rarely bend.

If...
Forum: 5th Generation Maxima (2000-2003)
11-06-2009, 09:56 PM
Replies: 18
Views: 1,101
Posted By LoveSick

If you change your oil periodically, you will not...

If you change your oil periodically, you will not see any benefit from pouring sea foam into your crank case.

I am not content with pouring sea foam into the gas tank, as there are dedicated fuel...
Forum: 5th Generation Maxima (2000-2003)
11-06-2009, 09:50 PM
Replies: 151
Views: 10,706
Posted By LoveSick

The moog suspension joints are a good replacement...

The moog suspension joints are a good replacement whenever the existing ones fail.

However, they are far from an upgrade, and I wouldn't recommend changing out perfectly functional stock ends for...
Forum: 5th Generation Maxima (2000-2003)
11-02-2009, 08:55 PM
Replies: 23
Views: 1,299
Posted By LoveSick

Hey, the guy is in Brooklyn. He is a...

Hey, the guy is in Brooklyn.

He is a regular poster on the Meguiar's detailing forum. He uses nothing but the best materials, and he has the knowledge and equipment to get those scratches out...
Forum: 5th Generation Maxima (2000-2003)
11-02-2009, 08:52 PM
Replies: 19
Views: 2,109
Posted By LoveSick

Evening, Do you make that claim as an...

Evening,

Do you make that claim as an independent consumer or as a former NNA employee? Because if you are asserting that statement as the latter, you have just undermined that assertion.

I...
Forum: 5th Generation Maxima (2000-2003)
11-01-2009, 01:42 AM
Replies: 23
Views: 1,299
Posted By LoveSick

Find someone with a rotary or a DA polisher and...

Find someone with a rotary or a DA polisher and he/she will be able to take those marks out with ease using a combination of compound and polishes. I know a potent person in NY that is able to do...
Forum: 5th Generation Maxima (2000-2003)
11-01-2009, 01:39 AM
Replies: 19
Views: 2,109
Posted By LoveSick

:thumbsup:

:thumbsup:
Forum: 5th Generation Maxima (2000-2003)
10-23-2009, 02:42 AM
Replies: 167
Views: 99,625
Posted By LoveSick

This is what the rubber looks like: ...

This is what the rubber looks like:
http://i6.photobucket.com/albums/y250/the_invisible/maxima%20radiator/3842bf6b.jpg

You may need two draining pans for the transmission cooling lines:...
Forum: 5th Generation Maxima (2000-2003)
10-22-2009, 07:05 PM
Replies: 39
Views: 5,467
Posted By LoveSick

The radiator support in the picture contains both...

The radiator support in the picture contains both the lower and the upper. Nissan does not sell just the lower support. They are connected and are only installed as an assembly.
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -7. The time now is 02:51 AM.