Maxima Forums

 
Page 1 of 12
1
2
3
11
Last »
Search: Posts Made By: M in KC
Showing results 1 to 25 of 292
Search took 0.81 seconds.
Forum: 4th Generation Maxima (1995-1999)
06-24-2021, 11:05 AM
Replies: 6
Views: 407
Posted By M in KC

Junk yard, Fastenal, MSC, McMaster-Carr. Or a...

Junk yard, Fastenal, MSC, McMaster-Carr. Or a die the right thread size and red locktite.
Forum: 4th Generation Maxima (1995-1999)
06-23-2021, 06:28 AM
Replies: 3
Views: 439
Posted By M in KC

Take the load off the front end and check out our...

Take the load off the front end and check out our components inner outer tie rod ends, ball joint, steering rack bushings, etc. The strut mounts are also suspect and a good starting point I would...
Forum: 4th Generation Maxima (1995-1999)
04-16-2020, 07:43 AM
Replies: 10
Views: 742
Posted By M in KC

Boss, I don't think that kit is what you are...

Boss, I don't think that kit is what you are after for a rear valve cover gasket job. You need Fel-Pro numbers or equivalent: VS50494R (yes I know it is the front and rear VC gaskets), MS91253,...
Forum: 4th Generation Maxima (1995-1999)
03-16-2020, 07:38 AM
Replies: 76
Views: 3,936
Posted By M in KC

And FWIW, I always buy two sets of Nissan only...

And FWIW, I always buy two sets of Nissan only O-rings for the water pump. If you destroy one or one set of O-rings due to improper install, you have a spare. Again I'll suggest only using a Nissan...
Forum: 4th Generation Maxima (1995-1999)
03-09-2020, 07:37 AM
Replies: 76
Views: 3,936
Posted By M in KC

^ B-I-N-G-O! Yes pressure test it. Compression...

^ B-I-N-G-O! Yes pressure test it. Compression test the cylinders and even consider a cylinder leak down test if your source(s) of coolant lose are not revealed by these tests.
Forum: 4th Generation Maxima (1995-1999)
03-04-2020, 06:40 AM
Replies: 77
Views: 3,693
Posted By M in KC

Another no/low buck diagnostic check would be to...

Another no/low buck diagnostic check would be to pull the spark plugs and take a look at them. Do any look like they have been steam cleaned? If so that would suggest to me that would be your...
Forum: 4th Generation Maxima (1995-1999)
02-25-2020, 06:22 AM
Replies: 2
Views: 408
Posted By M in KC

Define, best. For the money, the best for me was...

Define, best. For the money, the best for me was a JVC Double-DIN, KW-R935BTS. This is not a paid commercial for Crutchfield, but they do a nice job with their website guiding you to equipment that...
Forum: 4th Generation Maxima (1995-1999)
02-07-2020, 06:19 AM
Replies: 7
Views: 531
Posted By M in KC

Retrieve any stored DTC via a code reader or with...

Retrieve any stored DTC via a code reader or with a flat bladed screw driver at the ECM and report back. From the hip I would suggest looking at the MAF and the electrical connector at the MAF. ...
Forum: 4th Generation Maxima (1995-1999)
12-20-2019, 08:18 AM
Replies: 7
Views: 637
Posted By M in KC

Nice, glad you got it sorted.

Nice, glad you got it sorted.
Forum: 4th Generation Maxima (1995-1999)
12-16-2019, 07:57 AM
Replies: 7
Views: 637
Posted By M in KC

I agree with Turbobink. However if that is not...

I agree with Turbobink. However if that is not the source of your leak, run down to your local auto parts stores and check out their cooling system pressure tester via their loan-a-tool program. ...
Forum: 4th Generation Maxima (1995-1999)
12-11-2019, 08:45 AM
Replies: 7
Views: 3,969
Posted By M in KC

I'm not a paid spokesperson for Crutchfield and...

I'm not a paid spokesperson for Crutchfield and this is not an advert for them just my experiences. Crutchfield's website and tech services are extremely helpful. I installed a JVC KW-R930BTS from...
Forum: 4th Generation Classifieds (1995-1999)
11-20-2019, 06:27 AM
Replies: 2
Views: 377
Posted By M in KC

You/We need the code number on your ECU to match...

You/We need the code number on your ECU to match a replacement up with as they are not universal.
Forum: 4th Generation Maxima (1995-1999)
10-15-2019, 09:58 AM
Replies: 11
Views: 1,040
Posted By M in KC

Replace the small coolant hose under the throttle...

Replace the small coolant hose under the throttle body while you are there it is a huge PITA to replace simply by itself. Get this preformed hose straight from the dealer.
Forum: 4th Generation Maxima (1995-1999)
10-11-2019, 12:31 PM
Replies: 7
Views: 3,969
Posted By M in KC

Start by confirming you have voltage at the...

Start by confirming you have voltage at the designated wire coming out of the harness when turning on your radio. If so, then do the same at the electrical connector at the antenna's power unit. ...
Forum: 4th Generation Maxima (1995-1999)
09-30-2019, 06:51 AM
Replies: 4
Views: 1,396
Posted By M in KC

J, I just did this repair last week on my '97...

J, I just did this repair last week on my '97 after believing my mast needed to be wash in the "up" position at the car wash, rrrrgh. Anyway I got my replacement from these guys ...
Forum: 4th Generation Maxima (1995-1999)
08-20-2019, 08:46 AM
Replies: 29
Views: 2,226
Posted By M in KC

Absolutely check the lower radiator support. ...

Absolutely check the lower radiator support. Generally they fail right in the middle of the support look for excessive rust, metal delamination etc. They are fixable but again it would be a deduct...
Forum: 4th Generation Maxima (1995-1999)
07-22-2019, 06:52 AM
Replies: 21
Views: 3,229
Posted By M in KC

If it were me, and yes I've been there, I would...

If it were me, and yes I've been there, I would replace the flexible brake hoses, buy loaded rebuilt calipers, new pads and rotors and be done with it. At 24 year old your biggest issue will be...
Forum: 4th Generation Maxima (1995-1999)
07-19-2019, 06:02 AM
Replies: 5
Views: 2,248
Posted By M in KC

393K miles and 22 years later not a squeak one.

393K miles and 22 years later not a squeak one.
Forum: 4th Generation Maxima (1995-1999)
07-03-2019, 08:20 AM
Replies: 3
Views: 597
Posted By M in KC

Very common in these cars. Mine is currently...

Very common in these cars. Mine is currently unresponsive at any operating condition. I just choose to do without.
Forum: 4th Generation Maxima (1995-1999)
07-03-2019, 08:18 AM
Replies: 2
Views: 2,566
Posted By M in KC

Boss, if the circuit is rated for 140 amps, a 120...

Boss, if the circuit is rated for 140 amps, a 120 amp fusible link will fail every time as its not rated for that amount of current. Your approach is interesting as most will up size the fusible...
Forum: 4th Generation Maxima (1995-1999)
06-19-2019, 07:52 AM
Replies: 32
Views: 2,915
Posted By M in KC

Download the FSM as martyl45 has done for you...

Download the FSM as martyl45 has done for you above and grab your VOM, 12v power supply and non-contact infrared temp reader and start crossing things off. IMO if your fans run with 12v applied to...
Forum: 4th Generation Maxima (1995-1999)
06-03-2019, 07:00 AM
Replies: 7
Views: 1,551
Posted By M in KC

Can't go wrong with the General Altimax RT 43's. ...

Can't go wrong with the General Altimax RT 43's. I run them on my '97 SE great all season tire.
Forum: 4th Generation Maxima (1995-1999)
05-15-2019, 07:25 AM
Replies: 61
Views: 8,298
Posted By M in KC

21 glorious years, and closing in on 400,000...

21 glorious years, and closing in on 400,000 miles. This car has been a delight to own and operate. Alas, mine will most likely succomb to rust before the motor or trans fails. If I could find...
Forum: 4th Generation Maxima (1995-1999)
04-30-2019, 05:58 AM
Replies: 6
Views: 737
Posted By M in KC

Yes check you lower rad hose to t-stat...

Yes check you lower rad hose to t-stat connection. I had a ton of dried up coolant on mine. A quick hit with some steel wool and the hose to t-stat connections was tight again.
Forum: 4th Generation Maxima (1995-1999)
04-01-2019, 06:54 AM
Replies: 9
Views: 848
Posted By M in KC

Rad R&R on these cars is a 30 minute job. You...

Rad R&R on these cars is a 30 minute job. You are making the best decision to buy new. Denso makes top-shelf products you will be fine there. That is what I replaced mine with a couple years back,...
Showing results 1 to 25 of 292
 
Page 1 of 12
1
2
3
11
Last »


 
Forum Jump


All times are GMT -7. The time now is 07:03 AM.