Maxima Forums

 
Page 1 of 2
1
2
Search: Posts Made By: warlok
Showing results 1 to 25 of 41
Search took 0.04 seconds.
Forum: Tires and Wheels
09-13-2022, 01:55 PM
Replies: 0
Views: 446
Posted By warlok

Wheels from 03 Mustang on 05 Maxima

They are not mustang wheels.. I'm looking at some aftermarket wheels that were on a 2003 mustang for my 2005 Maxima SE. I know they are are 5x114.3 and 18" but not sure about backspacing/offset. Does...
Forum: 6th Generation Maxima (2004-2008)
09-10-2020, 05:45 AM
Replies: 14
Views: 2,657
Posted By warlok

Replaced alternator and flushed coolant. All good...

Replaced alternator and flushed coolant. All good now. Thanks all.
Forum: 6th Generation Maxima (2004-2008)
09-04-2020, 05:27 AM
Replies: 14
Views: 2,657
Posted By warlok

I saw this in another thread as well. Why is the...

I saw this in another thread as well. Why is the alternator so apt to take out batteries? I'm guessing that's what happened to the first battery, but how? Just because it's not charging shouldn't...
Forum: 6th Generation Maxima (2004-2008)
09-03-2020, 02:53 PM
Replies: 14
Views: 2,657
Posted By warlok

I'm gonna grab the TYC. Its 120 amp where the...

I'm gonna grab the TYC. Its 120 amp where the Remynis 110. And they are OEM for quite a few brands. Both are lifetime warranty. Thanks.
Forum: 6th Generation Maxima (2004-2008)
09-03-2020, 02:35 PM
Replies: 14
Views: 2,657
Posted By warlok

That's a good idea.. Any opinions on Remy, Wai...

That's a good idea..
Any opinions on Remy, Wai Global, or TYC? All new from Rock Auto.. I read TYC makes a lot of manufacturers OEM alternators.
Forum: 6th Generation Maxima (2004-2008)
09-03-2020, 05:39 AM
Replies: 14
Views: 2,657
Posted By warlok

Noticed a smell like burning plastic or rubber so...

Noticed a smell like burning plastic or rubber so as I would be replacing both belts with the alternator, I pulled the belt and while spinning the components by hand there was noise from the idler...
Forum: 6th Generation Maxima (2004-2008)
09-02-2020, 05:38 AM
Replies: 14
Views: 2,657
Posted By warlok

Low voltage while running.

05 SE, 107k miles. My month old battery was very low on voltage, had it checked and they replaced it. Car is now running correctly but when I put a voltmeter on the battery at about 1500 rpm, it's...
Forum: 6th Generation Maxima (2004-2008)
09-02-2020, 05:30 AM
Replies: 1
Views: 329
Posted By warlok

Looks like this was happening because my month...

Looks like this was happening because my month old battery was very low. Had it checked and they gave me a new one. Running fine right now but I don't know if the alternator is charging. But that's...
Forum: 6th Generation Maxima (2004-2008)
09-01-2020, 02:28 PM
Replies: 1
Views: 329
Posted By warlok

Limp mode when A/C is turned on.

Got a weird one here.. 05 maxima SE. Wife was driving and called saying the car has no power. Does nothing when throttle is pressed. Turned off A/C and it went away. I checked codes, there are none....
Forum: 6th Generation Maxima (2004-2008)
05-16-2016, 11:37 AM
Replies: 4
Views: 1,383
Posted By warlok

Well crap.. Decided to just try and disconnect...

Well crap.. Decided to just try and disconnect battery and spray some contact cleaner in the switches while rocking them back and forth. Apparently a bad idea. Now the power and source buttons work...
Forum: 6th Generation Maxima (2004-2008)
05-13-2016, 04:19 PM
Replies: 4
Views: 1,383
Posted By warlok

The drive through high school kid at Carl's Jr??...

The drive through high school kid at Carl's Jr?? I doubt he has spare money.. lol. I can do it with instructions. Do they come off with the airbag? Can't remove without removing airbag?
Forum: 6th Generation Maxima (2004-2008)
05-13-2016, 03:45 PM
Replies: 4
Views: 1,383
Posted By warlok

Need to remove steering wheel controls

The jackass at Carl's Jr spilled my soda in my 05 Maxima SE. Thankfully most went in my lap and not all over the seat. But some got inside the steering wheel controls and now they're sticky. They...
Forum: 6th Generation Maxima (2004-2008)
01-22-2015, 03:58 AM
Replies: 1,611
Views: 737,151
Posted By warlok

I'm in the exact same position.. Bought a case...

I'm in the exact same position.. Bought a case and did one drain and refill hoping for the best. Only been about 200 miles since but has gotten a bit worse. So I'm gonna change the solenoids and just...
Forum: 6th Generation Maxima (2004-2008)
01-21-2015, 03:46 PM
Replies: 1,611
Views: 737,151
Posted By warlok

I'm 99% sure I'm going to order the Rostra...

I'm 99% sure I'm going to order the Rostra solenoids in the next day or 2 and just wanted to ask... Should I drain and refill a couple times before or just after I replace the solenoids?
Forum: 6th Generation Maxima (2004-2008)
01-20-2015, 10:24 AM
Replies: 8
Views: 1,391
Posted By warlok

Since I drained and refilled (haven't driven it...

Since I drained and refilled (haven't driven it much since) it has again a few times hesitated and clunked from R-D and P-D. And just now started clunking and jerking some between 1-2 and if I coast...
Forum: 6th Generation Maxima (2004-2008)
12-23-2014, 11:13 AM
Replies: 8
Views: 1,391
Posted By warlok

Thanks for the reply. I drove it around for some...

Thanks for the reply. I drove it around for some errands today to get it hot and checked the fluid again, barely touched the dipstick. No leaks so :gotme:. Grabbed a case of Matic K yesterday (at...
Forum: 6th Generation Maxima (2004-2008)
12-22-2014, 09:23 AM
Replies: 8
Views: 1,391
Posted By warlok

Possible start of tranny problem..

Quick back story.. Had my 05 SE for 6 years. Got it with 65k and now has 90k. Wife only drives around town mostly. Don't know any history of fluid changes etc.. but I've never done it in the 25k...
Forum: 6th Generation Maxima (2004-2008)
02-28-2011, 10:02 PM
Replies: 22
Views: 20,618
Posted By warlok

Kryogen - If I get a chance tomorrow, I'll take...

Kryogen - If I get a chance tomorrow, I'll take pics of the old mounts where they are cracked and leaked..
Forum: 6th Generation Maxima (2004-2008)
02-28-2011, 09:59 PM
Replies: 22
Views: 20,618
Posted By warlok

Well.... After looking at the precat and seeing...

Well.... After looking at the precat and seeing that it has heat shields and plenty of other **** in the way, while then looking for **** to throw around my garage, I saw my biggest prybar sitting on...
Forum: 6th Generation Maxima (2004-2008)
02-27-2011, 11:40 PM
Replies: 22
Views: 20,618
Posted By warlok

Oil was right behind the rubber crack in mine.....

Oil was right behind the rubber crack in mine.. :mad:;)

Anyone think it's a bad idea to replace the bolt with a 1/2" grade 5 bolt? The original is .470" and the coating (I'm guessing) looks like...
Forum: 6th Generation Maxima (2004-2008)
02-26-2011, 07:38 PM
Replies: 22
Views: 20,618
Posted By warlok

Kryogen - I'm not sure what you mean by inserts??...

Kryogen - I'm not sure what you mean by inserts?? The only "inserts" I know of are the racingline ones that fill and stiffen the stock rubber in the mounts. The rubber in the stock mounts isn't...
Forum: 6th Generation Maxima (2004-2008)
02-26-2011, 07:32 PM
Replies: 22
Views: 20,618
Posted By warlok

I pulled the tranny mount, lifted the engine, and...

I pulled the tranny mount, lifted the engine, and shifted it as far over and forward as It would move. That's where I was at in the last pics.. I'm going to cut the bolt. Haven't got out there to do...
Forum: 6th Generation Maxima (2004-2008)
02-24-2011, 09:14 PM
Replies: 22
Views: 20,618
Posted By warlok

Yes, I did remove the Y-pipe. And yes, it's a...

Yes, I did remove the Y-pipe. And yes, it's a 5AT. Those were exactly the 3 options I was considering. I really don't want to split the tranny from the engine, or lower the subframe. I'm thinking...
Forum: 6th Generation Maxima (2004-2008)
02-23-2011, 10:11 PM
Replies: 22
Views: 20,618
Posted By warlok

By the way. The pics don't help much from the MMI...

By the way. The pics don't help much from the MMI instructions because they are of a 2.5L Altima and mine is a 3.5L maxima. The bolts face the opposite way on them. On mine, the rear pre-cat is in...
Forum: 6th Generation Maxima (2004-2008)
02-23-2011, 10:01 PM
Replies: 47
Views: 93,044
Posted By warlok

I started a new thread as this one was...

I started a new thread as this one was ressurected and old. Please take a look and give any thoughts.....
Showing results 1 to 25 of 41
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -7. The time now is 03:19 AM.