Maxima Forums

 
Page 1 of 2
1
2
Search: Posts Made By: domano 68
Showing results 1 to 25 of 33
Search took 0.04 seconds.
Forum: 4th Generation Maxima (1995-1999)
01-11-2012, 10:31 AM
Replies: 21
Views: 1,789
Posted By domano 68

Update: Lets start from square one. Car was...

Update:
Lets start from square one. Car was idling irradically and missing around 40mph.

Changed fron coils with BWDs. Missing and idle problems continued and CEL came on 1320 code.
...
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 05:55 PM
Replies: 21
Views: 1,789
Posted By domano 68

Ok, thanks for your information here. I do...

Ok, thanks for your information here. I do appreciate your time.

What I really want to understand is what physically would happen if I kept the BWDs and the P1320 code stayed lit. If its just a...
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 05:01 PM
Replies: 21
Views: 1,789
Posted By domano 68

Do you think the P1320 is a result of the BWD...

Do you think the P1320 is a result of the BWD coils and do you think the BWDs would be fine to keep? Just wondering if there would be any consequence of keeping these coils. Thanks.
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 04:33 PM
Replies: 21
Views: 1,789
Posted By domano 68

Its a 99. Thanks!

Its a 99. Thanks!
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 04:27 PM
Replies: 21
Views: 1,789
Posted By domano 68

Replaced the plugs about a month ago and are good...

Replaced the plugs about a month ago and are good to go. I'll reset the ECU and see what happens. Thanks for the info!
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 04:14 PM
Replies: 21
Views: 1,789
Posted By domano 68

I am not exactly certain when I got the CEL but...

I am not exactly certain when I got the CEL but it could have been recently. I swapped out 3 coils last week, then the other 3 today. So the CEL could be due to the new coils. On the flips side...
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 03:55 PM
Replies: 21
Views: 1,789
Posted By domano 68

Thanks for the info. No we used...

Thanks for the info.

No we used BWD/Intermodal coils at $70 a pop. I strongly do not want to put the junk Nissan coils back in since they pooped out at 60k. Why do you ask?
Forum: 4th Generation Maxima (1995-1999)
01-01-2012, 03:43 PM
Replies: 21
Views: 1,789
Posted By domano 68

Check engine light cycle time

I recently replaced my coil packs due to rough idle and missing upon acceleration. Right before I changed these, I CEL with a P1320 code.

The car runs much better now with the new coils but...
Forum: 4th Generation Maxima (1995-1999)
12-31-2011, 12:21 PM
Replies: 4
Views: 2,526
Posted By domano 68

Thanks guys!

Thanks guys!
Forum: 4th Generation Maxima (1995-1999)
12-31-2011, 11:09 AM
Replies: 4
Views: 2,526
Posted By domano 68

spark plug gap

Could not find this using the search function so need some help here.

Just replaced my spark plugs on my sister's 99 using platinum or double platinums; cannot recall. I did not check the gap...
Forum: 4th Generation Maxima (1995-1999)
12-24-2011, 02:58 PM
Replies: 83
Views: 144,674
Posted By domano 68

Is this a symptom of bad coil packs: Doing...

Is this a symptom of bad coil packs:
Doing around 40 and accelerating to to pass or go up a hill the car bogs down or cuts out for a couple seconds then accelerates as normal. Thanks!
Forum: 4th Generation Maxima (1995-1999)
12-24-2011, 11:42 AM
Replies: 10
Views: 873
Posted By domano 68

Will do. So, just out of curiosity, what if...

Will do. So, just out of curiosity, what if after I spray water on the belts it still sqeaks? What would that be? Thanks!
Forum: 4th Generation Maxima (1995-1999)
12-24-2011, 11:17 AM
Replies: 10
Views: 873
Posted By domano 68

high pitched sqeak at start-up

For about a week now, when I start my 99 there is a high pitched sqeak that last for about 2 seconds. Happens everytime I start it now. I had my belts changed about 3 weeks ago so I am wondering if...
Forum: 4th Generation Maxima (1995-1999)
11-19-2011, 12:59 PM
Replies: 83
Views: 144,674
Posted By domano 68

Do you have to remove the coil pack entirely when...

Do you have to remove the coil pack entirely when doing the resistance test? It would be a lot easier to just remove the connector and leave the coil pack in the cylinder connected to the spark...
Forum: 4th Generation Maxima (1995-1999)
10-03-2011, 09:53 AM
Replies: 16
Views: 7,262
Posted By domano 68

What section and page in the factory service...

What section and page in the factory service manual discusses how to test the ignition coils? Thanks.
Forum: 4th Generation Maxima (1995-1999)
09-08-2011, 10:48 AM
Replies: 16
Views: 7,262
Posted By domano 68

How much does a set of coil packs go for and...

How much does a set of coil packs go for and where in the fsm does it describe how to test ( what section)?

The car has 70k miles (didnt mention before)
Thanks!
Forum: 4th Generation Maxima (1995-1999)
09-08-2011, 08:28 AM
Replies: 16
Views: 7,262
Posted By domano 68

Thanks for your reply. I did check the post you...

Thanks for your reply. I did check the post you mentioned but was not certain about rear u2 sensor being the downstream sensor mentioned in the post. What is FPR? And what to check with fuel...
Forum: 4th Generation Maxima (1995-1999)
09-08-2011, 07:33 AM
Replies: 16
Views: 7,262
Posted By domano 68

Idle rough at stop lights

After cleaning the maf, tb, new plugs, and new pcv my sisters 99 still idles rough at lights. She has a cel w a p0138 code. I am not certain but is this the rear most o2 sensor? Also would a bad o2...
Forum: 4th Generation Maxima (1995-1999)
09-02-2011, 09:27 AM
Replies: 117
Views: 92,069
Posted By domano 68

Just cleaned my MAF, TB and new plugs in my 99...

Just cleaned my MAF, TB and new plugs in my 99 with 70k miles. Did this due to stalling at stop lights. It still is stalling.

I did not take the MAF out of the maf tube, just pulled the maf...
Forum: 4th Generation Maxima (1995-1999)
08-22-2011, 09:11 AM
Replies: 46
Views: 21,783
Posted By domano 68

I struggled with the rear plugs last time I...

I struggled with the rear plugs last time I changed these out. The rubber grommet in the spark plug socket has such a good grip on the plug, that the socket kept coming off of the extension and I...
Forum: Group Deals / Sponsors Forum
09-23-2010, 08:14 PM
Replies: 1,023
Views: 78,651
Posted By domano 68

Unable to locate a replacement radiator for my...

Unable to locate a replacement radiator for my 2001 Maxima SE auto. Can you send a link? TIA!
Forum: 5th Generation Maxima (2000-2003)
09-23-2010, 07:44 PM
Replies: 35
Views: 8,044
Posted By domano 68

Mine has a leak and currently searching for the...

Mine has a leak and currently searching for the source. I'll check here. Can you actually see the crack or is the engine running forcing the fluid out making it easy to find. Thanks!
Forum: 5th Generation Maxima (2000-2003)
09-23-2010, 07:20 PM
Replies: 167
Views: 99,617
Posted By domano 68

Great write up!!

Great write up!!
Forum: 5th Generation Maxima (2000-2003)
04-22-2010, 09:37 AM
Replies: 14
Views: 7,308
Posted By domano 68

Great stuff, thanks for the response!

Great stuff, thanks for the response!
Forum: 5th Generation Maxima (2000-2003)
04-22-2010, 08:47 AM
Replies: 14
Views: 7,308
Posted By domano 68

Just replaced mine on my 01 SE however I could...

Just replaced mine on my 01 SE however I could not get the pcv valve to seat flushed up against the block. Might be a dumb question here but is this necessary? It is in there tight as it sits now.
Showing results 1 to 25 of 33
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -7. The time now is 08:31 AM.