Maxima Forums

 
Page 1 of 3
1
2
3
Search: Posts Made By: saraara
Showing results 1 to 25 of 58
Search took 0.06 seconds.
Forum: 6th Generation Maxima (2004-2008)
11-01-2010, 02:18 PM
Replies: 525
Views: 121,730
Posted By saraara

Seems like someone is seeing some good bread and...

Seems like someone is seeing some good bread and butter.
Forum: 6th Generation Maxima (2004-2008)
11-01-2010, 11:03 AM
Replies: 1,611
Views: 737,012
Posted By saraara

I spoke to one of the tranny repair shop who is...

I spoke to one of the tranny repair shop who is considered as one of the reputable doing all higher end works. When I called these folks to ask to see if they can install this kit in my car; they...
Forum: 6th Generation Maxima (2004-2008)
10-31-2010, 06:54 PM
Replies: 1,611
Views: 737,012
Posted By saraara

I found THIS...

I found THIS (http://www.titantalk.com/forums/titan-faq-howto-area/107187-transgo-shift-kit-install-how.html) write-up about how to install transgo kit for nissan titan. I know maxima and Titan is...
Forum: Fluids and Lubricants
10-31-2010, 03:44 PM
Replies: 21
Views: 42,414
Posted By saraara

I am surprised to see no replies to your post....

I am surprised to see no replies to your post. Great write-up and nice tutorial. Thank you very much!!
Forum: 6th Generation Maxima (2004-2008)
10-31-2010, 11:52 AM
Replies: 338
Views: 61,794
Posted By saraara

Ok, I am not sure yet if I am also a victim...

Ok,

I am not sure yet if I am also a victim of bad tranny. May be someone can help me understand what’s going on and what will happen and perhaps when.

04 SE fully loaded with 110k miles...
Forum: 6th Generation Maxima (2004-2008)
06-20-2008, 07:32 PM
Replies: 38
Views: 14,774
Posted By saraara

Amazing that fuel damper fixed your problem as...

Amazing that fuel damper fixed your problem as mine fuel dampers were replaced by dealer (or they actually did not?) but that diesel sound is still there.
Forum: 6th Generation Maxima (2004-2008)
06-07-2008, 07:42 PM
Replies: 13
Views: 14,194
Posted By saraara

To my surprise, all bolts were clean but not like...

To my surprise, all bolts were clean but not like rusted what I was expected except for the sensor bolts. One side took me about little over 1 & 1/2 hour but the other side took me little less time....
Forum: 6th Generation Maxima (2004-2008)
06-07-2008, 08:34 AM
Replies: 13
Views: 14,194
Posted By saraara

Sorry I am new and not that expert in all kind of...

Sorry I am new and not that expert in all kind of repair works. Well took me about 3 hours to replace both hub assembly. ABS sensor came-out easily then what I thought. I had to use rubber hammer to...
Forum: 6th Generation Maxima (2004-2008)
06-06-2008, 05:00 AM
Replies: 13
Views: 14,194
Posted By saraara

I have that TSB but may be it was not so clear...

I have that TSB but may be it was not so clear for me to understand. I have bad hub/bearing assembly and I want to replace myself. I am confortable doing this job except ABS sensor removal that I...
Forum: 6th Generation Maxima (2004-2008)
06-05-2008, 04:56 PM
Replies: 13
Views: 14,194
Posted By saraara

Thanks majesticmaxima, I am replacing both rear...

Thanks majesticmaxima,
I am replacing both rear hub assembly so I was not sure how to remove ABS sensors. Does those sensors come out easy or need to spary wd-40 or anything else to pull out? Those...
Forum: 6th Generation Maxima (2004-2008)
06-05-2008, 03:05 PM
Replies: 13
Views: 14,194
Posted By saraara

Rear wheel ABS sensor removal

Does anyone know how to remove rear wheels ABS sensors? Do I need special tools or special care to remove? I appreciate for any help or procedure explanation.


Thanks
Forum: 6th Generation Maxima (2004-2008)
06-03-2008, 04:00 PM
Replies: 59
Views: 11,354
Posted By saraara

Believe me or not, try posi quiet semi-metalic...

Believe me or not, try posi quiet semi-metalic with rotorpros slotted rotors next time and you will be pleased you made that choise. I had first powerslots + hawk and second rotorpros + hawk set-up...
Forum: 6th Generation Maxima (2004-2008)
06-03-2008, 03:51 AM
Replies: 59
Views: 11,354
Posted By saraara

Did you do bed in procedure? If yes, check for...

Did you do bed in procedure? If yes, check for hub assembly play for card in spoke type of noise. Try an alignment of tires to eliminate shimmy if balance are done during new tire installation.
Forum: 6th Generation Maxima (2004-2008)
06-03-2008, 03:44 AM
Replies: 38
Views: 14,774
Posted By saraara

If you're under warranty then yes if you fight...

If you're under warranty then yes if you fight hard with them. I heared that going for tensioner and timing chain repair cause engine to eat fair amount of oil later on.
Forum: 6th Generation Maxima (2004-2008)
06-02-2008, 07:10 PM
Replies: 59
Views: 11,354
Posted By saraara

Did not read all reply but adding my own...

Did not read all reply but adding my own thoughts.

Check rotors closely and if you find like black spots or circular black marks on rotors, you better change either pads or rotors. I would...
Forum: 6th Generation Maxima (2004-2008)
06-02-2008, 06:55 PM
Replies: 38
Views: 14,774
Posted By saraara

To me, there are two issues here. 1. Clicking...

To me, there are two issues here.
1. Clicking noise at start-up from 2 sec to 15 sec and then goes away.
2. No noise at start-up but once car warm-up, engine sounds like a diesel engine.

Number...
Forum: 6th Generation Maxima (2004-2008)
05-31-2008, 04:55 PM
Replies: 38
Views: 14,774
Posted By saraara

Hi brio_max, I actually replaced my fuel...

Hi brio_max,

I actually replaced my fuel dampers few year ago and it did not make any change in noise. Dealer was telling me that this is normal and changing dampers wont make any difference, but...
Forum: 6th Generation Maxima (2004-2008)
05-26-2008, 03:46 PM
Replies: 10
Views: 865
Posted By saraara

Yes TBS repair will be free only if you're under...

Yes TBS repair will be free only if you're under warranty. But then again dealers will always try to avoid doing any TBS repair with saying no need for doing that job and everything is normal unless...
Forum: 6th Generation Maxima (2004-2008)
05-26-2008, 12:39 PM
Replies: 3
Views: 1,454
Posted By saraara

Keeping this thread alive per request. ...

Keeping this thread alive per request.

Thanks
Forum: 6th Generation Maxima (2004-2008)
05-26-2008, 12:34 PM
Replies: 24
Views: 5,095
Posted By saraara

Nice set-up ! I am not sure what was your...

Nice set-up !

I am not sure what was your motive going behind drilled rotors, I heard that drilled rotors cracks during heavy breaking or in long term run. I hope that's not true at least for...
Forum: 6th Generation Maxima (2004-2008)
05-26-2008, 12:30 PM
Replies: 38
Views: 14,774
Posted By saraara

jreilly04, are you serious? damn...that will be...

jreilly04, are you serious? damn...that will be like ouchhh for maxima owners if oil consumption that starts with the tickling noise. Mine does not eat any oil at this moment and I hope it always...
Forum: 6th Generation Maxima (2004-2008)
05-25-2008, 06:32 PM
Replies: 38
Views: 14,774
Posted By saraara

I am kind of agree with you mikesima. I googled...

I am kind of agree with you mikesima. I googled and found two 6th gen maxima running with the same reathom. Turning climate control off doesn't make any difference. Having nothing running in car...
Forum: 6th Generation Maxima (2004-2008)
05-25-2008, 04:48 PM
Replies: 38
Views: 14,774
Posted By saraara

Hmmm...mine is actually after I warm-up my car...

Hmmm...mine is actually after I warm-up my car for like 5 to 7 minutes for car to drop around 700 rpms. I can even hear it clearly at stop lights when I stop when all windows are rolled up. No...
Forum: 6th Generation Maxima (2004-2008)
05-25-2008, 01:28 PM
Replies: 38
Views: 14,774
Posted By saraara

Does my engine sound right?

http://www.supload.com/sound_confirm.php?get=1171902113.wav

Can you hear that click...click...click..click or dig...dig...dig...dig engine noise in idle?
Should I worry or this is normal for 04...
Forum: 6th Generation Maxima (2004-2008)
05-25-2008, 06:52 AM
Replies: 5
Views: 6,210
Posted By saraara

Are you able to do some minor work/job in your...

Are you able to do some minor work/job in your car?
1. jack-up your car at rear right end (thats where you have noise right?)
2. remove rear right wheel
3. Tight lugnut using spacers on only...
Showing results 1 to 25 of 58
 
Page 1 of 3
1
2
3


 
Forum Jump


All times are GMT -7. The time now is 03:33 AM.