Maxima Forums

Search: Posts Made By: blue92SE5spd
Showing results 1 to 8 of 8
Search took 0.12 seconds.
Forum: 3rd Generation Maxima (1989-1994)
03-30-2006, 06:10 PM
Replies: 8
Views: 908
Posted By blue92SE5spd

with the ignition on, engine not running, put...

with the ignition on, engine not running, put your positive probe of your meter in the wire in the center of the gray connector under the tps with negative probe on ground.tps voltage should be 0.4...
Forum: 3rd Generation Maxima (1989-1994)
03-21-2006, 05:13 PM
Replies: 189
Views: 4,830
Posted By blue92SE5spd

over 287xxx changed everything but engine, fuel...

over 287xxx changed everything but engine, fuel and brake lines
Forum: 3rd Generation Maxima (1989-1994)
03-19-2006, 12:00 PM
Replies: 23
Views: 594
Posted By blue92SE5spd

for those who ride the koni adjustable/eibach...

for those who ride the koni adjustable/eibach springs, what is the set-up you guys use for the koni in the front to make sure it doesn't blow the struts??
Forum: 3rd Generation Maxima (1989-1994)
03-19-2006, 11:43 AM
Replies: 15
Views: 772
Posted By blue92SE5spd

since i've changed the carbon canister filter the...

since i've changed the carbon canister filter the idle is right on cue and the power loss under 3500rpm is a little bit less noticeable.I tried grounding the vtc with an on/off switch to see if my...
Forum: 3rd Generation Maxima (1989-1994)
03-13-2006, 06:08 PM
Replies: 10
Views: 611
Posted By blue92SE5spd

bought brand new terminals from car quest, and...

bought brand new terminals from car quest, and after only 2 weeks, the battery terminal became black...any reason why??? the ground terminal still look like new.

thx
Forum: 3rd Generation Maxima (1989-1994)
03-13-2006, 06:03 PM
Replies: 42
Views: 2,107
Posted By blue92SE5spd

about the 5 speed swap, how do you get the wire...

about the 5 speed swap, how do you get the wire into the ecu connector for the power valve solenoid??and where can I get a surge tank to finally install the vi!!!

thanks
Forum: 3rd Generation Maxima (1989-1994)
02-28-2006, 05:15 PM
Replies: 15
Views: 772
Posted By blue92SE5spd

the knock sensor had been replaced.but I still...

the knock sensor had been replaced.but I still have a rough idle even if I changed all the vaccum hoses.
Forum: 3rd Generation Maxima (1989-1994)
02-28-2006, 04:56 PM
Replies: 15
Views: 772
Posted By blue92SE5spd

I have the same problem.The vtc's had been...

I have the same problem.The vtc's had been replaced, engine temp. sensor, o2 sensor, tps, all the wires from the ecu to the sensors are ok. fuses ok. no codes on the ecu. no power under 3500rpm and...
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -7. The time now is 07:04 PM.