Maxima Forums

 
Page 1 of 10
1
2
3
Last »
Search: Posts Made By: L0R1DA
Showing results 1 to 25 of 239
Search took 0.30 seconds.
Forum: Maximas for Sale / Wanted
01-15-2014, 07:14 PM
Replies: 13
Views: 4,457
Posted By L0R1DA

Hey everyone! Sorry I haven't updated, been busy...

Hey everyone! Sorry I haven't updated, been busy with work and the frigid cold snap we had :goofy:... Thank you for all the compliments! THE CAR IS STILL AVAILABLE! and I am taking $2200 as of now!...
Forum: Maximas for Sale / Wanted
12-19-2013, 09:37 PM
Replies: 13
Views: 4,457
Posted By L0R1DA

My loss is your gain! Crazy deal... $2300!!! NYC

Ok guys, I unfortunately have fell on some hard times and need to sell my baby the 1997 Mahogany Pearl Infiniti I30 :bawling: http://forums.maxima.org/customprofilepics/profilepic55783_1.gif. Here is...
Forum: 4th Generation Maxima (1995-1999)
08-03-2009, 02:17 PM
Replies: 28
Views: 31,355
Posted By L0R1DA

From what I gather, you likely overfilled the...

From what I gather, you likely overfilled the system which reduced the evaporator's capacity to evaporate the refrigerant, which means your compressor tried to compress a liquid (something a liquid...
Forum: 4th Generation Maxima (1995-1999)
08-03-2009, 02:02 PM
Replies: 1
Views: 464
Posted By L0R1DA

Looking for complete VQ35 swap for a 4th gen in Tri-State Area

Hey guys, been out of the loop with the forum for a while... is Tilly still doing these swaps in PA? I don't have the facilities to undertake this project myself so I'm looking to see if anyone is...
Forum: Infiniti I30/I35
07-05-2009, 07:23 AM
Replies: 15
Views: 7,515
Posted By L0R1DA

You guys seem to be a tad confused on oil...

You guys seem to be a tad confused on oil viscosity ratings. The first number is operating temp viscosity, the W stands for winterized, and the number that follows it is the maximum cold viscosity.
...
Forum: 4th Generation Maxima (1995-1999)
06-03-2009, 09:22 AM
Replies: 7
Views: 794
Posted By L0R1DA

You are probably experiencing a combination of...

You are probably experiencing a combination of seized strut bearings and worn load-carrying ball joints. I only hear you talking about your springs. When if ever have you replaced the struts? Your...
Forum: 4th Generation Maxima (1995-1999)
05-27-2009, 02:26 PM
Replies: 32
Views: 1,216
Posted By L0R1DA

If that is true? This is the law of physics my...

If that is true? This is the law of physics my friend, the dynamics of gas velocity is not a philosophical debate. A 3.5 yes, but this is a 4th gen forum, so there are only 3.0s, if you swapped the...
Forum: 4th Generation Maxima (1995-1999)
05-27-2009, 10:59 AM
Replies: 32
Views: 1,216
Posted By L0R1DA

Ok I am going to drop some knowledge for all you...

Ok I am going to drop some knowledge for all you individuals that are still perplexed by the exhaust performance debate...

The exhaust is merely a path for the exhaust gasses to pass through. If...
Forum: 4th Generation Maxima (1995-1999)
05-22-2009, 10:02 AM
Replies: 12
Views: 1,135
Posted By L0R1DA

As far as the $200ish range of headers for our...

As far as the $200ish range of headers for our cars is concerned, they are pretty much the same, XS Racing, Spyder, doesn't really matter they are all unequal length Y pipe shorty collectors. I...
Forum: Infiniti I30/I35
05-21-2009, 07:45 PM
Replies: 81
Views: 311,665
Posted By L0R1DA

I would check the wiring from your wheel speed...

I would check the wiring from your wheel speed sensors all the way up, as well. Especially before replacing an expensive module.
Forum: 4th Generation Maxima (1995-1999)
05-21-2009, 07:42 PM
Replies: 41
Views: 5,502
Posted By L0R1DA

Every brand of spark plugs uses a different...

Every brand of spark plugs uses a different internal resistor with a different ohm rating. These ohm ratings affect the spark strength and load on the coil packs in coil-on-plug systems. I don't know...
Forum: 4th Generation Maxima (1995-1999)
05-21-2009, 07:23 PM
Replies: 30
Views: 7,612
Posted By L0R1DA

The aux cooler should not mess with fluid...

The aux cooler should not mess with fluid pressure as liquids do not compress like gasses, they just flow.


O rly? States of matter 101 : a liquid takes on the shape of its container. Why do...
Forum: General Maxima Discussion
05-19-2009, 11:21 PM
Replies: 140
Views: 16,110
Posted By L0R1DA

HAHA oh man, what a find... there are two things...

HAHA oh man, what a find... there are two things most wrong with this contraption. Firstly, the front of the car actually looks pretty cool in a wannabe sort of way, but the back looks like a generic...
Forum: Audio and Electronics
05-19-2009, 12:27 AM
Replies: 9
Views: 695
Posted By L0R1DA

Touchscreen Talk

I'm looking for an all-in-one head unit touchscreen that will fit the stock dash trim in my 1997 I30 with minor modification at most (not looking to hack things up too much). Ideally would be nice to...
Forum: Supercharged/Turbocharged
05-18-2009, 09:22 PM
Replies: 54
Views: 13,140
Posted By L0R1DA

I'm loving your setup man, everything looks...

I'm loving your setup man, everything looks great. I like your turbo intake airbox even though I think in the interest of cleanliness you should have routed it through a vent in the fender, but its...
Forum: 4th Generation Maxima (1995-1999)
05-15-2009, 09:27 AM
Replies: 13
Views: 14,906
Posted By L0R1DA

Definitely "adjust" the hood latch in the front...

Definitely "adjust" the hood latch in the front between the horns with a slide hammer til it works right. Then put a little grease on it and you should never have a problem again.
Forum: 4th Generation Maxima (1995-1999)
05-15-2009, 09:16 AM
Replies: 45
Views: 1,725
Posted By L0R1DA

Dark brown fluid means it is burnt. I would make...

Dark brown fluid means it is burnt. I would make sure that the new radiator you purchased has internal transmission cooler lines, because it is very likely that you purchased one that does not have...
Forum: 5th Generation Maxima (2000-2003)
05-13-2009, 04:12 AM
Replies: 42
Views: 1,619
Posted By L0R1DA

Uh guys, in all your "brakes are so easy" ranting...

Uh guys, in all your "brakes are so easy" ranting I did not hear ANYBODY mention that the piston on the rear calipers needed to be screwed in and not pressed in like the fronts... this could easily...
Forum: Infiniti I30/I35
05-13-2009, 01:27 AM
Replies: 6
Views: 1,788
Posted By L0R1DA

Thanks for your input guys! burgy... I...

Thanks for your input guys!
burgy... I appreciate the offer! I don't know if I'm going to undertake the project though, would rather get off with minimal hassle at this point... but what else would...
Forum: 4th Generation Maxima (1995-1999)
05-09-2009, 03:51 AM
Replies: 23
Views: 1,497
Posted By L0R1DA

Chevron Techron is probably the best stuff as far...

Chevron Techron is probably the best stuff as far as the cheap in-tank additives go. The main drawback of these products however is that they lack the ability to lubricate. For all purpose petroleum...
Forum: Infiniti I30/I35
05-09-2009, 03:16 AM
Replies: 6
Views: 1,788
Posted By L0R1DA

Correcting beam pattern on ebay cefiro headlights

So I got the clear/chrome one-piece cefiro headlights off ebay ( i know, i know...) and I immediately noticed that the design of the reflector, oddly enough, completely eclipsed the front of the...
Forum: Infiniti I30/I35
05-07-2009, 02:52 PM
Replies: 9
Views: 1,048
Posted By L0R1DA

The top piece in the pic is not removable because...

The top piece in the pic is not removable because it is integrated into the radiator support. If you remove the bumper cover and the headlights you will see that the entire front of the frame is that...
Forum: 4th Generation Maxima (1995-1999)
05-07-2009, 12:58 PM
Replies: 46
Views: 1,961
Posted By L0R1DA

10 bucks says its your MAF.

10 bucks says its your MAF.
Forum: 4th Generation Maxima (1995-1999)
05-07-2009, 12:56 PM
Replies: 11
Views: 1,484
Posted By L0R1DA

Its definitely strut bearing related if they...

Its definitely strut bearing related if they haven't been replaced. Not a major issue or anything but if you felt like removing both front strut assemblies and installing new strut bearings with a...
Forum: 4th Generation Maxima (1995-1999)
05-07-2009, 12:53 PM
Replies: 2
Views: 685
Posted By L0R1DA

This sounds very interesting... keep us updated...

This sounds very interesting... keep us updated...
Showing results 1 to 25 of 239
 
Page 1 of 10
1
2
3
Last »


 
Forum Jump


All times are GMT -7. The time now is 03:08 AM.