Maxima Forums

Search: Posts Made By: spn350z
Showing results 1 to 8 of 8
Search took 0.12 seconds.
Forum: Fluids and Lubricants
03-05-2007, 10:08 PM
Replies: 83
Views: 3,431
Posted By spn350z

A different view: In my area we have three...

A different view:
In my area we have three "grades" 87 regular, 89 and 90-93 premium or super or ultimate grade. Depending on gas station the high grade will vary between 90 to 93 but the price...
Forum: 4th Generation Maxima (1995-1999)
03-05-2007, 09:07 PM
Replies: 55
Views: 2,833
Posted By spn350z

One thing not mentioned is tire pressure, it...

One thing not mentioned is tire pressure, it makes small difference but I would check this.

Any problems with tranny? Check to make sure auto tranny shifts. If manual clutch?
Forum: 4th Generation Maxima (1995-1999)
03-05-2007, 08:26 PM
Replies: 30
Views: 1,425
Posted By spn350z

My "short" harness has two wires on the remote...

My "short" harness has two wires on the remote end and only one wire near the sensor. I was informed that the "second wire" provides a ground shield hence NOT terminated near the sensor. Thus the...
Forum: 4th Generation Maxima (1995-1999)
03-05-2007, 08:04 PM
Replies: 34
Views: 3,218
Posted By spn350z

I replaced my at 140k along with clutch,...

I replaced my at 140k along with clutch, master/slave cylinders, upper and lower clutch hose and drive shafts and changed tranny fluid.

I had to do the clutch but things started showing iffy,...
Forum: 4th Generation Maxima (1995-1999)
03-05-2007, 03:38 PM
Replies: 71
Views: 49,318
Posted By spn350z

Good info sticks around for a long time. Love the...

Good info sticks around for a long time. Love the sound clip.
Forum: All Motor
02-28-2007, 06:38 AM
Replies: 12
Views: 3,396
Posted By spn350z

Things to look at while replacing clutch and...

Things to look at while replacing clutch and having most of the drive train off the car:
1) Seals
Rear Main, transmission and drive shaft. I would replace them if car had high mileage (100k) on...
Forum: 4th Generation Maxima (1995-1999)
02-26-2007, 01:22 PM
Replies: 20
Views: 943
Posted By spn350z

If changing engine to 3.5 would it require...

If changing engine to 3.5 would it require changing engine management computer (EMC) to accommodate newer engine?

I would love the extra power but not sure if I could go all the way and change...
Forum: 4th Generation Maxima (1995-1999)
02-26-2007, 01:17 PM
Replies: 23
Views: 1,024
Posted By spn350z

I changed mine on 4th gen at 80k miles. Plugs...

I changed mine on 4th gen at 80k miles. Plugs looked clean and no abnormal wear. Yes, I did change fuel filter at this time. An main belt (alternator/AC). Again just minor wear.

I was going on a...
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -7. The time now is 07:12 AM.