Search: Posts Made By: max808
Showing results 1 to 25 of 476
Search took 0.37 seconds.
09-21-2005, 11:39 AM
Replies: 7
Views: 493
Posted By max808

Based on the weight and USPS Priority Rates the...

Based on the weight and USPS Priority Rates the shipping is actually $18. If any of you noticed, this is shipping from Hawaii. Anyway, all of you know the FSM is the bible to repair the Max, and...
09-20-2005, 02:02 PM
Replies: 7
Views: 493
Posted By max808

1999 Maxima Factory Manual

I sold my car and no longer need my factory manual.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8001915696&sspagename=STRK%3AMESE%3AIT
05-12-2003, 08:03 PM
Replies: 3
Views: 479
Posted By max808

I bought a dash kit from them. It fit ok and all...

I bought a dash kit from them. It fit ok and all pieces are still in place. It's been about 2 years now.
05-10-2003, 12:37 PM
Replies: 4
Views: 554
Posted By max808

Clicking sound whlie full left turn

I'm getting a clicking sound when making a full right turn, normally in a parking lot where I need to make a sharp right turn. Is this signs of CV boot torn? Wheel bearings? It doesn't happen on...
05-10-2003, 12:35 PM
Replies: 3
Views: 509
Posted By max808

Wheel Vibration at 60+ MPH

I get a slight wheel vibration at speeds above 60 MPH. Any ideas? I had my wheels balanced twice and aligned. Also, all new tires. It vibrated before doing all the above.
05-10-2003, 12:27 PM
Replies: 2
Views: 564
Posted By max808

Amsoil Engine Flush

Has any tried the Amsoil Engine Flush. Was there any performance gain by cleaning out the varnish and sludge from your engine?
05-07-2003, 11:59 PM
Replies: 12
Views: 617
Posted By max808

I drove it today without any sound. If it is the...

I drove it today without any sound. If it is the timing chain or tensioner, will the knocking sound be constant or intermittent?
05-07-2003, 01:41 AM
Replies: 12
Views: 617
Posted By max808

It's a knocking sound. I believe it's coming...

It's a knocking sound. I believe it's coming from near the acc. belts. It goes away after a few minutes. I've searched and found explainations like timing giude/tesioner, , low idle, low oil...
05-07-2003, 12:05 AM
Replies: 12
Views: 617
Posted By max808

knocking sound, goes away after few minutes???

Any ideas what this could be?
11-01-2002, 06:26 PM
Replies: 33
Views: 920
Posted By max808

Alka Plus

I bought a kit from these guys about 1 1/2 years ago. So far so good. As far as the heat and peeling off, I live in Hawaii, it don't get much hotter and humid than here.
10-12-2002, 08:20 PM
Replies: 2
Views: 490
Posted By max808

Redline D4

Redline D4 ATF is good fluid.
09-04-2002, 04:37 PM
Replies: 6
Views: 1,520
Posted By max808

Blower Motor Resistor

It sounds like your resistor is not working. The resistor allows 1-3 fan speeds to work and it is off when level 4 fan speed is selected.

Go to:...
08-21-2002, 09:28 PM
Replies: 8
Views: 504
Posted By max808

i don't know why either. i should have asked...

i don't know why either. i should have asked more questions. i took my car to an ac shop and they said the compressor was bad (making lots of noise and smoking). I asked them for a fix and they...
08-21-2002, 07:46 PM
Replies: 8
Views: 504
Posted By max808

Re: info for those who need a new a/c compressor.... read on..

yeah i did that with my old sentra se-r. the guy who did it said the belt wouldn't last very long. i sold it the following weekend and got my max. what's with nissans ac compressors?
08-14-2002, 05:20 PM
Replies: 14
Views: 525
Posted By max808

ignition coils

my ignition coils needed to be replaced too. Nissan did it under warranty, but said it was not covered past 3yr/36k. it would have cost me $750. i had 50k miles.
08-13-2002, 07:10 PM
Replies: 6
Views: 589
Posted By max808

fog light install

the link worked for me. here it is anyway.

http://www.seas.ucla.edu/%7Echeston/fogs/fogpg1.GIF
http://www.seas.ucla.edu/%7Echeston/fogs/fogpg2.GIF...
07-26-2002, 07:43 PM
Replies: 27
Views: 2,573
Posted By max808

Re: As stated before - read the online store

let me fill you in, you're not doing anything possitive for your business going back and forth posting. although you may be technically correct, you should just say in the future you will include...
07-02-2002, 05:01 PM
Replies: 34
Views: 597
Posted By max808

that wiring harness from that guy in taiwan isn't...

that wiring harness from that guy in taiwan isn't as good as the one put out by APC. you get what you pay for.
07-02-2002, 01:16 AM
Replies: 34
Views: 597
Posted By max808

sounds like relay or bulb problems. good...

sounds like relay or bulb problems. good harnesses allows you to use both low and high beams.
07-01-2002, 06:17 PM
Replies: 6
Views: 1,396
Posted By max808

NTB99-031A

Brakes - Rear Noise (Groan/Humming) After Brake Release
Classification:
BR99-002A

Reference:
NTB99-031A

Date:
May 14, 1999
06-30-2002, 01:51 AM
Replies: 34
Views: 597
Posted By max808

Keep it. I think the APC wire guage is better to...

Keep it. I think the APC wire guage is better to handle higher wattages. Also, the yellow wire insulation is better.
06-29-2002, 07:20 PM
Replies: 34
Views: 597
Posted By max808

Re: headlight harness isnt working good .......

If you're looking for a harness I have an APC one I can sell you. I used it 2 weeks and changed my mind about increasing the stock 45/65 wattage.
06-28-2002, 06:51 PM
Replies: 24
Views: 15,209
Posted By max808

i'd change both every 15-30k miles. good...

i'd change both every 15-30k miles. good preventive maintenance. if your car is still running good on your original fuel filter, consider yourself lucky!
06-28-2002, 06:45 PM
Replies: 17
Views: 9,598
Posted By max808

i have the same upgrade apc harness and it's...

i have the same upgrade apc harness and it's working fine. i hope mines don't melt. what kind and watt bulbs are you guys running?
06-28-2002, 06:35 PM
Replies: 7
Views: 556
Posted By max808

fyi, part number for the whole kit is 999f1-7h000.

fyi, part number for the whole kit is 999f1-7h000.
Showing results 1 to 25 of 476
 


 
Forum Jump


All times are GMT -7. The time now is 07:48 AM.