Maxima Forums

Search: Posts Made By: mahmoudh
Showing results 1 to 8 of 8
Search took 0.04 seconds.
Forum: 4th Generation Maxima (1995-1999)
08-27-2009, 02:06 PM
Replies: 9
Views: 1,287
Posted By mahmoudh

1008 code fixed by new CPSCSV

I finally replaced the CPSCSV, hoses, bracket and nuts as shown above. So far the code has not re-appeared. What is strange is that the resistance across the pins on the old part are OK per FM....
Forum: 4th Generation Maxima (1995-1999)
08-06-2009, 04:38 AM
Replies: 9
Views: 1,287
Posted By mahmoudh

Thanks for the pics. That is the valve I ohmed...

Thanks for the pics. That is the valve I ohmed out and it shows movement. Also the mushroom valve in your picture and canister are listed as possible causes in later years. These parts are...
Forum: 4th Generation Maxima (1995-1999)
08-06-2009, 04:20 AM
Replies: 9
Views: 1,287
Posted By mahmoudh

Pmohr, you are correct - The FSM does call for...

Pmohr, you are correct - The FSM does call for testing it with IACV - which has an identical 6 pin connector. I will be testing with IACV to see if the valve behaves any different . By the way, there...
Forum: 4th Generation Maxima (1995-1999)
08-05-2009, 01:08 PM
Replies: 9
Views: 1,287
Posted By mahmoudh

Thanks for your help. I did check the connector...

Thanks for your help. I did check the connector for damage and also the valve shaft moves forward and backward with ignition so I assume all is well there. Hoses are good. I did not check the...
Forum: 4th Generation Maxima (1995-1999)
08-04-2009, 02:06 PM
Replies: 53
Views: 4,389
Posted By mahmoudh

A knock sensor will retard timing and affect...

A knock sensor will retard timing and affect starting. It will also throw a code but will not light up the CEL. You should read code using ECU (See Sticky) or have Autozone pull the codes for free.
Forum: 4th Generation Maxima (1995-1999)
08-04-2009, 01:59 PM
Replies: 4
Views: 529
Posted By mahmoudh

Double check the MAF connector which you had to...

Double check the MAF connector which you had to remove to install the starter. It is in the air box. Reset the ECU (Check stickies for procedure) and see it it goes away.
Did you have any other...
Forum: 4th Generation Maxima (1995-1999)
08-04-2009, 01:43 PM
Replies: 9
Views: 1,287
Posted By mahmoudh

Thanks for posting for me - Bottom line question...

Thanks for posting for me - Bottom line question I need help with is this - What is causing my CEL 1008 in the 95 maxima with Calif Spec? My CPSCSV ohms out fine. I am also getting poor gas mileage....
Forum: 4th Generation Maxima (1995-1999)
07-31-2009, 02:58 PM
Replies: 9,763
Views: 1,013,363
Posted By mahmoudh

Help - Confused by Sticky for Code 1008

Hi,
I am new to the board having recently bought a 95 Maxima Calif Emissions but appreciate the wealth of info and experience that is available here.
In trying to figure out my 1008 code (P0443) I...
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -7. The time now is 07:13 AM.