Maxima Forums

Search: Posts Made By: kahuna825
Showing results 1 to 8 of 8
Search took 0.07 seconds.
Forum: 4th Generation Maxima (1995-1999)
05-20-2010, 06:30 PM
Replies: 631
Views: 82,650
Posted By kahuna825

1999 Max. 158,033 miles on it. I bought the car...

1999 Max. 158,033 miles on it. I bought the car with 49,500 (appx) and have had to change the alternator once, the A/C Compressor, and the muffler replaced. Other than brake and oil changes, this car...
Forum: 4th Generation Maxima (1995-1999)
05-20-2010, 06:41 AM
Replies: 9
Views: 770
Posted By kahuna825

If they have been grinding, check for a seal gone...

If they have been grinding, check for a seal gone bad in the caliper, not allowing the cylinder to retract (I had same problem). Like earlier poster said, if it's been grinding that long, you need to...
Forum: 4th Generation Maxima (1995-1999)
04-25-2010, 01:25 PM
Replies: 106
Views: 117,349
Posted By kahuna825

I had to do mine to, but just replaced the A/C...

I had to do mine to, but just replaced the A/C Compressor and works really well. Very quiet and A/C cool.
Forum: 5th Generation Maxima (2000-2003)
02-27-2009, 08:27 AM
Replies: 7
Views: 803
Posted By kahuna825

Also check to make sure the cable is not...

Also check to make sure the cable is not sticking. It could be frayed at some position and will not allow it to retract to home position.
Forum: 5th Generation Maxima (2000-2003)
02-27-2009, 08:21 AM
Replies: 29
Views: 1,891
Posted By kahuna825

I've had mine do the same thing and it seems to...

I've had mine do the same thing and it seems to smooth out after a little while.

I replaced the plugs recently and have not had it since, not to say that was it just have not had the problem...
Forum: Advanced Suspension, Chassis, and Braking
02-24-2009, 10:27 AM
Replies: 14
Views: 2,232
Posted By kahuna825

It is possible that the piston in the caliper is...

It is possible that the piston in the caliper is sticking and could be coming out at a slight angle. The piston seal could be worn and not allowing the piston to retract inside the caliper fully. I...
Forum: 5th Generation Maxima (2000-2003)
02-24-2009, 05:44 AM
Replies: 7
Views: 1,162
Posted By kahuna825

I would check the wheel bearings, maybe see if...

I would check the wheel bearings, maybe see if you have a tear in the boot. The bearing on that side may be drying out.
Forum: 6th Generation Maxima (2004-2008)
02-24-2009, 05:39 AM
Replies: 24
Views: 1,495
Posted By kahuna825

Respectfully, the only way the rotors would crack...

Respectfully, the only way the rotors would crack is if there were a crack in the rotor prior to heat treatment. Rotors generally have a tolerance of HRC 15-25 (Rockwell Hardness) and will not crack...
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -7. The time now is 06:16 AM.