Greddy emanage A/F harness pinouts

brusk · 06-03-2008, 06:53 PM

Does anybody know the pinouts for hooking up the Greddy A/F harness on a emanage ultimate. Everybody seems to be sold out of the harness so I was just going to make a temporary one for 30 minutes of work to check the AFR and make a few minor adjustments then take it out again.

*pmohr* · 06-03-2008, 09:08 PM

We should have a couple at the shop, I'll see if I can't find out for you tomorrow.

Just send me a PM tomorrow mid-day sometime to remind me (or PM Merlyn, he's on the org more during the day than I am, he'll let me know).

*The Wizard* · 06-03-2008, 11:13 PM

Not following you. The optional A/F harness needs to tie into your wideband.

You can get the A/F harness here. Parts seem to always be in stock here. Great site IMO.

http://www.mohdparts.com/emanage/#E-...tional%20Parts

brusk · 06-04-2008, 07:23 AM

Yeah i ordered the wideband and the harness but then got a call back the next day saying that they actually didn't have one and greddy had them on back order. Which I don't understand since it's only like a two connector few wire piece. PMOHR I'll PM you but I talked to somebody at altered monday and said they didn't have any in stock.

*Merlyn* · 06-04-2008, 09:38 AM

You can custom make a wideband harness, which I actually have a custom made one...

PMohr and I did this and it worked... simply you only use 2 of the 3 connectors (unless you are hooking up 2 widebands) but we were able to use wire for a headphone (for my LM-1) and wire from a computer fan (3 pin out). It requires filing the connector down a little to fit, but none the less with a multimeter / guess and check we were able to make our own wideband cable for a temp solution until I purchased one...