Search: Posts Made By: jagshark89
Showing results 1 to 21 of 21
Search took 0.05 seconds.
07-20-2012, 01:58 PM
Replies: 12
Views: 1,376
Posted By jagshark89

added ground wires and now only missing cylinder...

added ground wires and now only missing cylinder 2 however still no start. I am suspecting spark plugs may be fouled I am going to put new ones in and try to start again
07-20-2012, 01:19 AM
Replies: 12
Views: 1,376
Posted By jagshark89

I will give this a try later today and see if it...

I will give this a try later today and see if it helps.
07-19-2012, 03:38 PM
Replies: 12
Views: 1,376
Posted By jagshark89

anyone else have any input on this bizarre problem

anyone else have any input on this bizarre problem
07-19-2012, 11:43 AM
Replies: 12
Views: 1,376
Posted By jagshark89

On this engine the negative on the battery is...

On this engine the negative on the battery is running directly to the engine not the transmission. Should I try running it to the transmission instead.
07-19-2012, 11:34 AM
Replies: 12
Views: 1,376
Posted By jagshark89

I remember seeing that before throughout the...

I remember seeing that before throughout the forum, but I think that when that is an issue the car does not crank at all and this engine started up several times before it just stopped starting out...
07-19-2012, 11:19 AM
Replies: 12
Views: 1,376
Posted By jagshark89

I didnt sand down the mating surface. However my...

I didnt sand down the mating surface. However my grounds appear to be good. His car is a 95 maxima the engine came from a 96 maxima my car is a 98 maxima that i used the sensors from to test.
07-19-2012, 10:46 AM
Replies: 12
Views: 1,376
Posted By jagshark89

Weirdest No Start Ever... Please Help

A friend of mine blew his headgasket and decided to get a new engine so I decided I would do him a favor and replace the engine for him. I have done 4 maxima engine swaps in the past time consuming...
Forum: All Motor
08-04-2010, 06:04 PM
Replies: 14
Views: 1,503
Posted By jagshark89

i disconnected the exhaust before the cat and...

i disconnected the exhaust before the cat and their was no change still glowed, would the exhaust leak cause or affect the problem im having
Forum: All Motor
08-03-2010, 08:02 PM
Replies: 14
Views: 1,503
Posted By jagshark89

I tore the engine down and the timing was spot...

I tore the engine down and the timing was spot on. I tried switching the fuel rail. Tomorrow I am going to do a leakdown test tommorow
Forum: All Motor
07-28-2010, 05:53 PM
Replies: 14
Views: 1,503
Posted By jagshark89

I just pulled a my codes and I have a code for...

I just pulled a my codes and I have a code for the ref crankshaft position sensor could that retard the timing enough to cause the glowing
Forum: All Motor
07-28-2010, 11:56 AM
Replies: 14
Views: 1,503
Posted By jagshark89

I dont know the name of the headers Ive had them...

I dont know the name of the headers Ive had them for probably a year and a half now. I have been looking to get some more since they are beginning to crack, probably because i bought them from an...
Forum: All Motor
07-28-2010, 12:34 AM
Replies: 14
Views: 1,503
Posted By jagshark89

im sure that its just the rear header ive looked...

im sure that its just the rear header ive looked at it in both day and night. The emanage hasnt been tuned yet i just have the basic setup running on it. I havent adjusted any of the fuel maps on it.
Forum: All Motor
07-27-2010, 11:02 PM
Replies: 14
Views: 1,503
Posted By jagshark89

the front header is completely normal not even a...

the front header is completely normal not even a hint of glowing. I did want to add in that the idle is a little rough and i am running emanage ultimate. I'm not sure if this problem is related to...
Forum: All Motor
07-27-2010, 09:46 PM
Replies: 14
Views: 1,503
Posted By jagshark89

Glowing Header

Since 3.5 swap into 4th gen maxima with 5spd swap. I have a glowing header on only one bank, the bank nearest the firewall, Its glowing a bright orange not long after running the engine at idle maybe...
05-05-2010, 11:06 PM
Replies: 2
Views: 1,038
Posted By jagshark89

thats what i was beginning to think since i...

thats what i was beginning to think since i switched the car over to manual and i know where a manual ecu is should i just get that one
05-05-2010, 08:13 AM
Replies: 2
Views: 1,038
Posted By jagshark89

Limp Mode

What would cause the ecu to stop sending spark to cylinders 2 and 3 and then when I unplug the crank sensor (ref) it then provides spark as normal and yes I have already changed the crank sensor.
04-23-2010, 07:38 PM
Replies: 9
Views: 1,216
Posted By jagshark89

Thanks for responding but I figured out the...

Thanks for responding but I figured out the problem amazingly today. There is a break somewhere in the harness for the sensor. I cut it from the ecu and at the center and ran my own direct line and...
04-22-2010, 06:03 PM
Replies: 9
Views: 1,216
Posted By jagshark89

Supercharged vq35 swap

Ok I am going to try and condense this as much as possible. I have a 1998 maxima in which I just swapped in a 2008 vq35 from a maxima with about 35,000 miles on it. I have looked through several...
02-15-2010, 08:45 PM
Replies: 4
Views: 467
Posted By jagshark89

I just talked with the seller he just received...

I just talked with the seller he just received the transmission back at his place. Fedex made the decision that the package was damaged themselves and automatically returned it. I just spoke with the...
02-14-2010, 05:38 PM
Replies: 4
Views: 467
Posted By jagshark89

WTB-5spd transmission

Looking to buy a 4th gen 5spd transmission. Getting ready to perform 5spd swap and vq35 swap supercharged. I ordered one from ebay but fedex damaged the transmission during shipment. I am now looking...
01-21-2010, 10:30 PM
Replies: 0
Views: 285
Posted By jagshark89

WTB:5 Speed Manual Transmission

Looking to purchase a 5 speed manual transmission and/or related parts for an auto to manual swap. Please include price/s shipped to 33056. Thank you in advance.
Showing results 1 to 21 of 21


 
Forum Jump


All times are GMT -7. The time now is 01:26 PM.