Maxima Forums

 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: quiksilver20004
Showing results 1 to 25 of 117
Search took 0.07 seconds.
Forum: 5th Generation Maxima (2000-2003)
03-22-2012, 08:07 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Is the car throwing any codes? There are many...

Is the car throwing any codes? There are many things that can cause an issue like this, a code would help narrow things down
Forum: 5th Generation Maxima (2000-2003)
12-07-2011, 07:35 PM
Replies: 27
Views: 2,074
Posted By quiksilver20004

So what ended up being wrong??

So what ended up being wrong??
Forum: 5th Generation Maxima (2000-2003)
11-25-2011, 02:07 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Have you checked your fuel pressure regulator?

Have you checked your fuel pressure regulator?
Forum: 5th Generation Maxima (2000-2003)
11-25-2011, 02:05 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Well if you have a spark problem or an injector...

Well if you have a spark problem or an injector problem then thats what your going to have to do. you can put a plug in the coil and ground it to the engine while cranking and it should spark. an...
Forum: 5th Generation Maxima (2000-2003)
11-24-2011, 04:48 PM
Replies: 27
Views: 2,074
Posted By quiksilver20004

Your input shaft bearings are shot. When you put...

Your input shaft bearings are shot. When you put it in gear its is torquing sideways and not engaging the gears on the counter shaft correctly so the are binding and jumping. Helical cut gears do not...
Forum: 5th Generation Maxima (2000-2003)
11-24-2011, 04:42 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

p1800 is in relation to your VIAS control...

p1800 is in relation to your VIAS control solenoid, small potatoes compared to the p0301 which is a #1 cylinder misfire.
I would start with a spark test first off then do a compression and cylinder...
Forum: 5th Generation Maxima (2000-2003)
11-24-2011, 09:51 AM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Agree 100% I have watched technicians do this and...

Agree 100% I have watched technicians do this and end up replacing a part when all they may have needed to replace was just a plug end so $10 fix instead of $200
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 11:58 PM
Replies: 5
Views: 1,651
Posted By quiksilver20004

Any time man. Everyone on here is really cool and...

Any time man. Everyone on here is really cool and always willing to help. Never hesitate to ask!!

Let me know what he says
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 11:41 PM
Replies: 5
Views: 1,651
Posted By quiksilver20004

If a normal OBDII scanner is not showing any...

If a normal OBDII scanner is not showing any codes then i would take it to an independent shop with a good scan tool and have it checked. You can take it to the dealership but they usually charge...
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 11:27 PM
Replies: 5
Views: 1,651
Posted By quiksilver20004

You need to go somewhere and have the codes...

You need to go somewhere and have the codes pulled. Most auto parts stores will do it for free. Even though the lights arnt on there should still be history codes. These lights coming on doesnt...
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 11:11 PM
Replies: 27
Views: 2,074
Posted By quiksilver20004

Ok im not understanding this jerking issue. is it...

Ok im not understanding this jerking issue. is it happening when you go to shift into gear or is it when you have it in gear and are depressing the clutch to move? Im a heavy line technician so i...
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 10:55 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

The sensor is easy to replace as long as you...

The sensor is easy to replace as long as you disable the SIR system. What did you do to diagnose it? I am a master certified mechanic and there are many different things that will set a SIR light for...
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 10:52 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

so you are just going to upgrade a single coil...

so you are just going to upgrade a single coil pack? Before throwing parts at the car you need to go thru and figure out what is causing the problem. Figure out whether it is a controller problem or...
Forum: 5th Generation Maxima (2000-2003)
11-23-2011, 10:48 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

4.7 with filter

4.7 with filter
Forum: 5th Generation Maxima (2000-2003)
05-12-2011, 03:50 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Never rule it out. If the engine had been...

Never rule it out. If the engine had been misfiring then it was dumping raw fuel into the cat, which will clog it quickly. When it gets clogged badly enough it will start building much higher than...
Forum: 5th Generation Maxima (2000-2003)
05-01-2011, 12:46 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

This is normal. The sensor is looking for a...

This is normal. The sensor is looking for a certain amount of oil pressure so it will flicker as your motor builds oil pressure whenever you start it. when the sensor is warm the resistance is...
Forum: 5th Generation Maxima (2000-2003)
04-28-2011, 06:53 AM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Ok this is what happens with high milage...

Ok this is what happens with high milage transmissions that have never been serviced. The clutch discs inside an auto trans have friction surfaces made of paper (yes paper). As you put miles on your...
Forum: 5th Generation Maxima (2000-2003)
04-27-2011, 06:21 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

You can buy O2 simulators or there are threads on...

You can buy O2 simulators or there are threads on the net that will tell you exactly how to make your own from radio shack. The radio shack way is cheaper but that is dependent on your electrical...
Forum: 5th Generation Maxima (2000-2003)
04-27-2011, 11:01 AM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

Need a good scan tool to take a movie of the...

Need a good scan tool to take a movie of the PID's under normal conditions and then when the car is experiencing the problem. You should find some significantly different numbers when you compare the...
Forum: 5th Generation Maxima (2000-2003)
04-27-2011, 10:50 AM
Replies: 35
Views: 7,236
Posted By quiksilver20004

No their not the same, but when it comes to wheel...

No their not the same, but when it comes to wheel base and vehicle design they are very similar. Meaning the rearend out of that should be the easiest of all to swap, not that it will be easy.
Forum: 5th Generation Maxima (2000-2003)
04-26-2011, 08:11 PM
Replies: 35
Views: 7,236
Posted By quiksilver20004

The VK56VD is a 5.6 L (5552 cc) 32-valve, DOHC,...

The VK56VD is a 5.6 L (5552 cc) 32-valve, DOHC, Direct Injection Gasoline (DIG) aluminum-alloy V8 and features Nissan's advanced VVEL (Variable Valve Event & Lift System). The direct injection system...
Forum: 5th Generation Maxima (2000-2003)
04-26-2011, 06:27 PM
Replies: 35
Views: 7,236
Posted By quiksilver20004

See i dont understand why people think it is so...

See i dont understand why people think it is so rediculous. The J30 is basically the same car with a VG30 which is only a few inches shorter than a V8. If i run a slim radiator with fans on the front...
Forum: 5th Generation Maxima (2000-2003)
04-26-2011, 05:17 PM
Replies: 35
Views: 7,236
Posted By quiksilver20004

RWD VK56VD

So i posted this thread before but somehow it got closed and i couldnt reply to my own stuff. Messed up right? Anyways heres the body of it.

So im starting to compile my list of parts for a RWD V8...
Forum: 5th Generation Maxima (2000-2003)
04-26-2011, 04:51 PM
Replies: 17,746
Views: 1,436,093
Posted By quiksilver20004

So not new here but i have an issue. I started...

So not new here but i have an issue. I started this thread http://forums.maxima.org/5th-generation-maxima-2000-2003/632425-rwd-vk56vd.html a few hours ago and now somehow it is closed. How does this...
Forum: 5th Generation Maxima (2000-2003)
04-26-2011, 03:06 PM
Replies: 12
Views: 1,714
Posted By quiksilver20004

RWD VK56VD?

So im starting to compile my list of parts for a RWD V8 swap on my 01 maxima. At this point i have a line on a new VK56VD but now am trying to decide what platform i want to use for the rear end. Was...
Showing results 1 to 25 of 117
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump


All times are GMT -7. The time now is 06:16 AM.