Maxima Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: po8pimp
Showing results 1 to 25 of 495
Search took 0.10 seconds.
Forum: 6th Generation Maxima (2004-2008)
03-17-2021, 05:41 PM
Replies: 2
Views: 1,654
Posted By po8pimp

just grease it up. You can use any lubricant that...

just grease it up. You can use any lubricant that is not water-based. Even Vaseline will work. Pull handle out and hold it that way while greasing. Then cycle a few times. I've had this issue and it...
Forum: 6th Generation Maxima (2004-2008)
03-17-2021, 05:37 PM
Replies: 4
Views: 1,154
Posted By po8pimp

You could always fiberglass in a 3 way toggle or...

You could always fiberglass in a 3 way toggle or rocker switch. Poor design for sure.
Forum: 6th Generation Maxima (2004-2008)
03-17-2021, 05:32 PM
Replies: 3
Views: 947
Posted By po8pimp

I would do as mentioned and see what gear you are...

I would do as mentioned and see what gear you are in and if you can manually shift down or up. If stuck in 5th with no CEL, could be either your CSP sensors or your trans. The TCMs don't usually go...
Forum: 6th Generation Maxima (2004-2008)
03-17-2021, 05:29 PM
Replies: 3
Views: 947
Posted By po8pimp

It went to 5th gear because that is the fail safe...

It went to 5th gear because that is the fail safe for the transmission. Pulling key and restarting forces engine to run it's electronic checks. If all is well, it will clear and start correctly. If...
Forum: 6th Generation Maxima (2004-2008)
04-25-2019, 11:10 AM
Replies: 2
Views: 697
Posted By po8pimp

There is a whole writeup about this towards the...

There is a whole writeup about this towards the top. Please take a few minutes to read through and see if the issues are similar and which fix is right for you.
Forum: 6th Generation Maxima (2004-2008)
04-25-2019, 10:49 AM
Replies: 1,611
Views: 737,220
Posted By po8pimp

There are a lot out there that fit exactly what...

There are a lot out there that fit exactly what you are saying. Side mechanics and car salesman do exactly this. Buy the cars, fix them and sell them for huge profit gains.
Forum: 6th Generation Maxima (2004-2008)
04-08-2018, 05:36 PM
Replies: 1,611
Views: 737,220
Posted By po8pimp

You my friend have the Camshaft/Crankshaft...

You my friend have the Camshaft/Crankshaft Position Sensor Error. Will cause Limp mode and the U1000 (generic electrical code to trans) and possibly the p0882. Replace both CSP sensors with OEM and...
Forum: 6th Generation Maxima (2004-2008)
04-08-2018, 05:30 PM
Replies: 1,611
Views: 737,220
Posted By po8pimp

I'm not sure you can "Tune" the solenoids. I...

I'm not sure you can "Tune" the solenoids. I didn't do the solenoid replacement yet, just the shift kit. Might want to open it back up and check everything over again make sure you didn't miss...
Forum: 6th Generation Maxima (2004-2008)
04-08-2018, 05:17 PM
Replies: 1
Views: 779
Posted By po8pimp

Yet another Key Fob Mystery

So here it is. My car sat a while when I was driving my Z around and the battery died. Swapped it with a new one and noticed my Aftermarket alarm key fob range went to crap along with the ability...
Forum: 6th Generation Maxima (2004-2008)
03-05-2017, 01:09 PM
Replies: 2
Views: 594
Posted By po8pimp

http://www.superstreetonline.com/how-to/wheels-tir...

http://www.superstreetonline.com/how-to/wheels-tires/1507-understadning-wheel-fitment-offset-rim-sizing/

I recommend reading this. It is a good read and will answer all your questions. Good luck...
Forum: 6th Generation Maxima (2004-2008)
03-05-2017, 12:59 PM
Replies: 0
Views: 589
Posted By po8pimp

6th gen Movie scene

Saw John Wick 2? Well if you have then you might have seen the 6th gen maxima that was able to stop his Mustake... Unfortunate how it all plays out for the Max, but in the end it had it's part in...
Forum: 6th Generation Maxima (2004-2008)
02-11-2016, 07:37 PM
Replies: 10
Views: 1,495
Posted By po8pimp

sounds like a cam shaft position sensor problem

sounds like a cam shaft position sensor problem
Forum: 6th Generation Maxima (2004-2008)
02-03-2016, 09:39 PM
Replies: 29
Views: 6,764
Posted By po8pimp

Nice looking good as always Deus

Nice looking good as always Deus
Forum: 6th Generation Maxima (2004-2008)
03-04-2015, 06:36 PM
Replies: 3
Views: 3,269
Posted By po8pimp

You can do pretty much anything. The real...

You can do pretty much anything. The real question is the amount of money you want to put into it. You could put a hemi in there if you have enough money. Start with what you are willing to spend...
Forum: 6th Generation Maxima (2004-2008)
03-04-2015, 05:37 PM
Replies: 6
Views: 1,442
Posted By po8pimp

holy crap haven't seen anything posted from you...

holy crap haven't seen anything posted from you here in a while. You gonna be autocrossing again this year? It was nice keeping up with your build and adventures with the maxima. good to see you...
Forum: 6th Generation Maxima (2004-2008)
02-24-2015, 05:19 PM
Replies: 1
Views: 1,696
Posted By po8pimp

I think it could be the Bank 1 Sensor 2 O2 sensor...

I think it could be the Bank 1 Sensor 2 O2 sensor and the Vent Control Valve. If they hooked up the Consult tool and scanned the car, then they gave you the right diagnostic. Not saying you should...
Forum: 6th Generation Maxima (2004-2008)
02-24-2015, 04:59 PM
Replies: 2
Views: 4,297
Posted By po8pimp

There is only one 6th gen that has that type of...

There is only one 6th gen that has that type of power and that is Chernmax. He has his turbo'd. The transmission he put in was done by Level 10 transmission. This transmission can probably handle...
Forum: 6th Generation Maxima (2004-2008)
02-22-2015, 10:07 AM
Replies: 2
Views: 2,161
Posted By po8pimp

These will help you get the job done. Good luck...

These will help you get the job done. Good luck and let us know if you need anymore guidance.

http://my6thgen.org/f278/2004-nissan-max-radio-wiring-diagram-27248/
and ...
Forum: 6th Generation Maxima (2004-2008)
02-22-2015, 09:56 AM
Replies: 2
Views: 2,161
Posted By po8pimp

Sounds like you might not have grounded it...

Sounds like you might not have grounded it correctly. DO NOT PUT BLACK TO BLACK. Your ground goes to a ground on the car. Find a good ground point like a screw or something that is touching the...
Forum: 6th Generation Maxima (2004-2008)
01-17-2015, 03:24 PM
Replies: 126
Views: 180,658
Posted By po8pimp

No warranty covered it

No warranty covered it
Forum: 6th Generation Maxima (2004-2008)
01-17-2015, 03:23 PM
Replies: 54
Views: 38,127
Posted By po8pimp

Nope sorry I was wrong 2 years 9 months old lmo

Nope sorry I was wrong 2 years 9 months old lmo
Forum: 6th Generation Maxima (2004-2008)
01-15-2015, 05:10 PM
Replies: 78
Views: 23,718
Posted By po8pimp

Seriously 3 year old thread. Takes 30 min for...

Seriously 3 year old thread. Takes 30 min for most not all.
Forum: 6th Generation Maxima (2004-2008)
01-15-2015, 05:07 PM
Replies: 126
Views: 180,658
Posted By po8pimp

Definitely agree, however had mine done at like...

Definitely agree, however had mine done at like 40k miles. Frustrating for sure.
Forum: 6th Generation Maxima (2004-2008)
01-15-2015, 05:03 PM
Replies: 1
Views: 647
Posted By po8pimp

Sounds like CSP sensors are going. This happened...

Sounds like CSP sensors are going. This happened to me. No codes at first. Then it spit them out a few days later. If it is, recommend replacing with OEM only. Will save you in the long run.
Forum: 6th Generation Maxima (2004-2008)
01-15-2015, 05:01 PM
Replies: 54
Views: 38,127
Posted By po8pimp

You just replied to a 9 month old post

You just replied to a 9 month old post
Showing results 1 to 25 of 495
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -7. The time now is 08:54 PM.