Search: Posts Made By: njmaxseltd
Showing results 1 to 25 of 488
Search took 0.21 seconds.
04-02-2016, 08:33 PM
Replies: 11
Views: 971
Posted By njmaxseltd

Your insurance company totaled the car for that? ...

Your insurance company totaled the car for that? Perhaps you should shop around for another insurance company in the future.

Pull the claim, fix the car and continue to enjoy driving it for...
03-18-2016, 03:53 AM
Replies: 2
Views: 703
Posted By njmaxseltd

No body shop will spot in 3 stage pearl. They...

No body shop will spot in 3 stage pearl. They can spot in the base and blend in the pearl, then the entire surface needs to be cleared.
03-17-2016, 09:22 AM
Replies: 38
Views: 4,246
Posted By njmaxseltd

The key is not only torquing it correctly, but...

The key is not only torquing it correctly, but torquing it while the arm is in the ride height position. That places the bushing in a neutral position, allowing the arm to move freely throughout...
03-15-2016, 05:23 AM
Replies: 29
Views: 5,357
Posted By njmaxseltd

What code is it throwing?

What code is it throwing?
03-14-2016, 01:13 PM
Replies: 7
Views: 2,486
Posted By njmaxseltd

Water will continue to make it's way past the...

Water will continue to make it's way past the window belt moldings and into the door.
You need to put the drains back in place or your doors will rust from the inside out.
03-14-2016, 01:10 PM
Replies: 29
Views: 5,357
Posted By njmaxseltd

If you keep replacing the same part, and the...

If you keep replacing the same part, and the problem continues to happen over and over again, then I think it's time you start looking at something else as the cause.

The MAF sensor doesn't pick...
03-14-2016, 04:44 AM
Replies: 26
Views: 1,748
Posted By njmaxseltd

Good clean install!

Good clean install!
03-14-2016, 04:41 AM
Replies: 7
Views: 2,486
Posted By njmaxseltd

If you seal the window molding to the glass, the...

If you seal the window molding to the glass, the window will become inoperable.
Like the sunroof, water does indeed run down into the inner door and by design come out the drain holes. You need...
03-10-2016, 09:02 AM
Replies: 7
Views: 685
Posted By njmaxseltd

Check the cold idle linkage and plunger (wax...

Check the cold idle linkage and plunger (wax motor). It's down under the TB, to the left. It's job is to open the throttle plate slightly when the engine has cooled off for easier starts. If the...
03-10-2016, 08:59 AM
Replies: 4
Views: 1,111
Posted By njmaxseltd

Ahh, the 99 misfire once again. Coils, you can...

Ahh, the 99 misfire once again. Coils, you can try to clean the section where the spring meets the coil in the stalk, or just replace them. The misfires usually show up under a load because the...
03-10-2016, 08:57 AM
Replies: 18
Views: 12,786
Posted By njmaxseltd

Just go to AutoZone and get what ever they have.

Just go to AutoZone and get what ever they have.
03-09-2016, 01:13 PM
Replies: 12
Views: 3,853
Posted By njmaxseltd

Unlikely, if you had any air the pedal would have...

Unlikely, if you had any air the pedal would have been soft the whole time.
03-09-2016, 01:00 PM
Replies: 14
Views: 906
Posted By njmaxseltd

This isn't going to happen if the trans was...

This isn't going to happen if the trans was indeed very low on fluid. Once it's starts to slip, or the TQ doesn't have adequate liquid in it and the clutch packs lose pressure, there's no burning...
03-09-2016, 12:54 PM
Replies: 14
Views: 906
Posted By njmaxseltd

This is clearly not the recommended maintenance...

This is clearly not the recommended maintenance for a transmission in a 4th gen Maxima.
03-09-2016, 12:41 PM
Replies: 12
Views: 3,853
Posted By njmaxseltd

Chewing gum on the floor?

Chewing gum on the floor?
03-09-2016, 04:25 AM
Replies: 10
Views: 1,763
Posted By njmaxseltd

So you pretty much closed the thread at the start.

So you pretty much closed the thread at the start.
03-07-2016, 06:48 AM
03-02-2016, 10:15 AM
Replies: 15
Views: 1,535
Posted By njmaxseltd

The chain and tensioner should be ok in your 98. ...

The chain and tensioner should be ok in your 98. Earlier 95-96's had weak tensioners.
03-02-2016, 07:16 AM
Replies: 15
Views: 1,535
Posted By njmaxseltd

At 110K the car really doesn't need to much...

At 110K the car really doesn't need to much rebuilding. These engines are almost bullet proof. Definitely look closely at all the seals, they dry up with age. The two o-rings are a must if you...
03-01-2016, 07:00 AM
Replies: 16
Views: 1,020
Posted By njmaxseltd

Mods, if you can, please acknowledge this as my...

Mods, if you can, please acknowledge this as my resignation and pass the power to Turbobink.
02-29-2016, 11:09 AM
Replies: 16
Views: 1,020
Posted By njmaxseltd

I miss the Max...

It's been close to 8 months now that he's gone. I've got a brand new 4 Runner, which I do love. It's like a floating couch, drives excellent but doesn't compare in the handling and "fun" area to...
02-23-2016, 12:58 PM
Replies: 4
Views: 1,377
Posted By njmaxseltd

Sounds like 4th gear is gone. If you just leave...

Sounds like 4th gear is gone. If you just leave it in D and accelerate, does the transmission attempt to shift all the way through or does it only shift 1-2-3 and remain there?
02-18-2016, 12:59 PM
Replies: 10
Views: 17,910
Posted By njmaxseltd

:laugh:

:laugh:
02-15-2016, 07:46 AM
Replies: 18
Views: 1,974
Posted By njmaxseltd

Going from your 97 to a 98 or even an 04 model...

Going from your 97 to a 98 or even an 04 model isn't buying you that much more car. It could in fact, buy you the same maintenance costs you're at now with your 97.

My .02 - Save a little more $$...
01-26-2016, 07:03 AM
Replies: 18
Views: 1,542
Posted By njmaxseltd

It's definitely worth more then 2400, that's what...

It's definitely worth more then 2400, that's what I sold my 99 SE-L with 225K on the clock.
Throw him a reasonable offer, you might get lucky.
Showing results 1 to 25 of 488
 


 
Forum Jump


All times are GMT -7. The time now is 01:29 AM.