NitrousDiscuss dry, wet, and direct port nitrous setups. How many shots can you handle?
Welcome to Maxima.org!
Welcome to Maxima.org,
You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join Maxima.org today!
It was mine. Man thought you forgot about that, I know I did. here's some proof that at one time it was alot better looking.
this is a before and after shot with my dry and custom zex wet kit, no more zex box and zex tps
that was a few minutes after the wet kit was installed and I had not checked to make sure everything was working correctly and if everything was located in it's final resting place. but since then most of the wires, vac lines have been shorten, shrink wraped and cleaned up since that pic's. I have not taken a pic of the entire engine bay but here's what I have
__________________ My Cardomain _ _Maxima runs 13.4@109
Dyno:? whp & ? wtq
Nitrous PB: 13.4@110mph
All Motor PB: 14.0@99mph
3280lb with driver, full trim, rims, spare, jack, fluids, etc & notorized proof
here's some proof that I changed the injen and started to clean up the engine bay
I'll take a pic of the entire engine bay to show what it looks like now, btw did you start on your nitrous setup and I already have a vac can thanks thought. I attemped to pm you but you were over loaded
__________________ My Cardomain _ _Maxima runs 13.4@109
Dyno:? whp & ? wtq
Nitrous PB: 13.4@110mph
All Motor PB: 14.0@99mph
3280lb with driver, full trim, rims, spare, jack, fluids, etc & notorized proof
Werd, It's definitly looking better, and I can't beleive I forgot about the Injen!
Haven't installed the juice yet, but within the next few days I am dropping the engine to install some rev-up cams and a different clutch & tranny, after that it's on for sure man!
Werd, It's definitly looking better, and I can't beleive I forgot about the Injen!
Haven't installed the juice yet, but within the next few days I am dropping the engine to install some rev-up cams and a different clutch & tranny, after that it's on for sure man!
I didn't forget, I am going to redo the injen and make it a realy cold air intake and not just a short ram air
good luck with the project, track season is almost here late feb for us in philly. I am hoping to be around 300whp by then. make sure you post some times
__________________ My Cardomain _ _Maxima runs 13.4@109
Dyno:? whp & ? wtq
Nitrous PB: 13.4@110mph
All Motor PB: 14.0@99mph
3280lb with driver, full trim, rims, spare, jack, fluids, etc & notorized proof