|
Summer Donna Matt haha.....
I installed my Progress RSB without ramps. My driveway in my old house(where I did the install) slanted down toward the house, so it had a slight slant up from the street to the sidewalk.......
I pulled my car in the top of the driveway facing the house, with the arse end overhanging the downslope going to the street (basically with the rear wheels on the sidewalk at a good enough spot for me to fit under the rear)
I DID need to use my car jack to take one rear wheel off at a time to make installing a couple of the brackets easier, but other than that......no ramps were needed.....
Wirelessdude, call me if you have any questions cause Im not sure if what i just wrote made any sense haha
__________________
-- Progress Springs w/ Tokico Illuminas - Progress Rear Sway Bar - Otto FSTB - Courtesy Nissan RSTB - J30 Front brake calipers w/ RTP Blanks and Hawk HPS Pads - JWT Pop Filter Intake - Ground Wire Kit - Unorthodox Racing Lightened Crank Pulley - Warpspeed Y, High Flow Cat, Custom B and Dynomax Muffler - Red/White Tails - Clear Corners --
|
- 2009 Subaru WRX - 2008 4Runner SportEdition - 1990 Cherokee Laredo - 1970 Triumph GT6 Mk2
Linear Mode
