landover50

I just ordered some cats and will be replacing them next week ('05 Maxima SL). I've been looking at it trying to see what needs to be done. Are there any tips on the process? It seems like a few of the bolts/shields may be difficult to get to.

For the firewall-side cat-is it all accessed from below?

Any general tips to smoothing out the process would be appreciated. Thanks for the help.

piggylover1985

It will be alot easier to do from underneath, you might have to bend the heat shield out of the way. Would be much simple if you have impact gun and a torch :-)

Kryogen

Go to the petstore and get a new cat. Smoothing out the process would require sandpaper.

RAZ76

iTrader: (8)

If you have tho ask these questions tell me that yo never done this beofre. It's going to be a knuckle buster for sure. Not an easy job by any means, good luck.