NWP BBTB 75MM with P2135 code
#1
NWP BBTB 75MM with P2135 code
So after working my 12hr shift, I started my car with the SES light on and car gauge pro app showed the P2135 code where I couldn't accelerate pass 10mph with the pedal to the floor....I pulled over, turn the car off, then fired it back up, and there was some mild throttle fluctuations, but I was able to get home without any problems, at this point there weren't any problems as far as RPMs going over 2500. Today I started her up, and after warming her up, the RPMs hold steady at around 1000 where it used to be around 700 RPMs normally....has anyone seen this problem before? I contacted NWP, and was advised to replace the wiring harness, hopefully this clears up the issue