HOW TO: o2 sim install.....
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (4)
Join Date: Oct 2003
Location: Port st Lucie
Posts: 2,536
HOW TO: o2 sim install.....
sup guys...... i did this on a fed spec 2k on the o2 sensoron the cat....
i bought the o2 sim from cattmann, the colors on their o2 sim are as follows...
black = ground
red = +12 volt
yellow 1 = first signal wire
yellow 2 = second signal wire
now i connected mine before the o2 sensor harness under the car, it was straight forward
black to black
red to red
and
one of the yellows to the white wire, but remember you must cut, NOT SPLICE the white wire and connect the sim's yellow wire to feed back to the ECU.
DISCLAIMER: I AM NOT LIABLE IF YOU MESS YOU CAR UP IN ANYWAY!
i bought the o2 sim from cattmann, the colors on their o2 sim are as follows...
black = ground
red = +12 volt
yellow 1 = first signal wire
yellow 2 = second signal wire
now i connected mine before the o2 sensor harness under the car, it was straight forward
black to black
red to red
and
one of the yellows to the white wire, but remember you must cut, NOT SPLICE the white wire and connect the sim's yellow wire to feed back to the ECU.
DISCLAIMER: I AM NOT LIABLE IF YOU MESS YOU CAR UP IN ANYWAY!
Thread
Thread Starter
Forum
Replies
Last Post
KnowledgeBorn
General Maxima Discussion
30
04-17-2001 01:19 PM
KnowledgeBorn
3rd Generation Maxima (1989-1994)
13
04-14-2001 01:45 PM