1st Dyno today!
#1
1st Dyno today!
I had to drive almost 20 miles to get to it and ran the car pretty hard to get there on time which I'm sure hurt my results. 2k2 Auto
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
#2
Guest
Posts: n/a
Re: 1st Dyno today!
Originally posted by Virus
I had to drive almost 20 miles to get to it and ran the car pretty hard to get there on time which I'm sure hurt my results.
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
I had to drive almost 20 miles to get to it and ran the car pretty hard to get there on time which I'm sure hurt my results.
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
204hp
219tq
but it was 40 degrees out, and probably 50 or 55 in the garage...
so that helped...plus they put a HUGE fan in front of my car to help keep it cool.
-vq
#4
I did a 3rd gear pull like everyone said to. I hope that was right. Y and B pipes are getting installed tomorrow. They also told me that better spark plugs might help. They said something about the ignition was lacking a bit.
#5
Originally posted by Virus
I did a 3rd gear pull like everyone said to. I hope that was right. Y and B pipes are getting installed tomorrow.
I did a 3rd gear pull like everyone said to. I hope that was right. Y and B pipes are getting installed tomorrow.
fan is required....they gave me three fans when my max was dynoed.
there was another boosted max (maxxboost00) getting dyno tuned and they had to bring a fan to the engine bay to cool it down between runs. they had 10 runs at least.
#6
Re: 1st Dyno today!
Originally posted by Virus
I had to drive almost 20 miles to get to it and ran the car pretty hard to get there on time which I'm sure hurt my results. 2k2 Auto
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
I had to drive almost 20 miles to get to it and ran the car pretty hard to get there on time which I'm sure hurt my results. 2k2 Auto
209hp
220tq
Is this good numbers for just a UDP and FrankenCar w/Apexi?
#8
Originally posted by blubyu2k2
if you can post the graph I would like to compare it to mine. I only got 211whp and 224tq with the y and b pipe. I just want to compare curves.
Matt
if you can post the graph I would like to compare it to mine. I only got 211whp and 224tq with the y and b pipe. I just want to compare curves.
Matt
I probably won't be going to the track for a while unless someone can twist my wife's arm I just hate going alone.
#9
Originally posted by Virus
If you can guide me through posting them, I'd be happy to.
I probably won't be going to the track for a while unless someone can twist my wife's arm I just hate going alone.
If you can guide me through posting them, I'd be happy to.
I probably won't be going to the track for a while unless someone can twist my wife's arm I just hate going alone.
Matt
Thread
Thread Starter
Forum
Replies
Last Post