|
ok well it's all done now. i had a bit of trouble finding the right place to grind the bulbs. I decided not to touch the housings, rather to grind the bulbs like greeny. I have a submission for the writeup
take a thin strip of paper or something, half an inch wide and long enough to wrap around the notched section of the 9004 bulb. take a marker, and mark each groove in the 9004 light, and make sure to cross-mark the top notch (a + sign) to indicate that you will line it up there on the 9007 bulb. Now take that paper and wrap it around the 9007 bulb and line up the top notch, and take a centerpunch and make a small mark through the marked notches from the 9004 into the plastic of the 9007, so you'll know where to start grinding exactly. Do the same thing on your other 9007 bulb, and now you will grind in exactly the right spot, without wasting time test-fitting and adjusting and eyeballing and etc etc like I had to.
I'll get a road test tomorrow morning, at the latest. I go into work at 5am so it'll still be very dark out.
|