Ive somewhat polished the manifold, i only did the top half of the manifold because for one the bottom half isnt seen (duh), and second the bottom half seemed to be a bit rougher than the top half. This could use a lot more sanding and polishing but i did what i could and gave up. Its pretty tedious. make an offer.
Last edited by MaximaSpd85; 05-01-2008 at 08:45 PM.
Keep at it. I have about 60 hours into the one in this photo and its still not done. Little by little it will pay off if you plan on staying with the USIM.
Keep at it. I have about 60 hours into the one in this photo and its still not done. Little by little it will pay off if you plan on staying with the USIM.
now is time to do the valve cover
__________________ My Cardomain _ _Maxima runs 14.30 N/A
3.5/SSIM/N/E
Dyno:? whp & ? wtq
Nitrous PB: 13.4@109mph
All Motor PB: 14.0@99mph
Looking to join the 300whp club in 2008
3280lb with driver, full trim, rims, spare, jack, fluids, etc and notorized proof
__________________ My Cardomain _ _Maxima runs 14.30 N/A
3.5/SSIM/N/E
Dyno:? whp & ? wtq
Nitrous PB: 13.4@109mph
All Motor PB: 14.0@99mph
Looking to join the 300whp club in 2008
3280lb with driver, full trim, rims, spare, jack, fluids, etc and notorized proof
If you're willing to ship to Canada, I might be interested too...Depending on shipping charges cause its pretty heavy. Here's my postal code for accurate shipping
M4J 3V3
PM me an amount you want and I'll see if its doable.
_
Linear Mode
