Maxima Forums - View Single Post

Pugman · 04-19-2007, 06:28 PM

Hello Puppetmaster,

I was talking to you a few months ago about installing o2 simulator. I just got one from www.o2sim.com. After reading your post I have a few questions. Your post is for your 2002 maxima. I have 2001 maxima. The connector colors are a little different. See attached picture. I am getting the P0420 code. (Secondary sensor Bank 1 is third connector from left). The wire harness at bottom of connector is white. The 4 wires coming out the top of connector are (White - Black - Pink - Red/Yellow). Am I correct in saying the following. (White = SIGNAL) (Black = GROUND) (Pink = HEATER) (Red/Yellow = POWER). I can follow your post for hooking simulator to connector. I just need to know if I am labeling the 4 wires correctly.

Thanks,
Pugman

04-19-2007, 06:28 PM	#19
Pugman Newbie - Just Registered Join Date: Dec 2006 iTrader: (0) Posts: 11	Simulator Install Hello Puppetmaster, I was talking to you a few months ago about installing o2 simulator. I just got one from www.o2sim.com. After reading your post I have a few questions. Your post is for your 2002 maxima. I have 2001 maxima. The connector colors are a little different. See attached picture. I am getting the P0420 code. (Secondary sensor Bank 1 is third connector from left). The wire harness at bottom of connector is white. The 4 wires coming out the top of connector are (White - Black - Pink - Red/Yellow). Am I correct in saying the following. (White = SIGNAL) (Black = GROUND) (Pink = HEATER) (Red/Yellow = POWER). I can follow your post for hooking simulator to connector. I just need to know if I am labeling the 4 wires correctly. Thanks, Pugman