View Single Post
Old 07-16-2003, 09:29 PM   #25
SteVTEC
Dyno plot says I have the most area under the Administrator curve
 
SteVTEC's Avatar
 
Join Date: Jul 2001
iTrader: (0)
Posts: 6,972

I have the same hesitation issue right now. You get on the gas and you start accelerating, but then there is this momentary lag for just an instant, and then you're back to accelerating again, right? If so, I'm getting this from lower RPM's also, not just above 3k.

Coil #6 went bad awhile ago. Replaced. Hesitation still there occasionally. Knock sensor is now bad. Bypassed temporarily with 470k resistor. Hesitation still there. More frequently. Tracked timing on OBD-II logger while driving. Lag does not follow timing advance/retard (thought it might have been related to the knock sensor), so it's not that.

I'll try this Coil #2 trick with wrapping the boot.


While I'm ordering my knock sensor, I think I'll probably order another a front and a rear coil for not if but WHEN I need them, and some other stuff too.
__________________
Total Power Area Under the Curve Divided by Weight STILL oWnZ j0o
SteVTEC is offline   Reply With Quote